I20.10-0001-06
1 Poly-V belt
2 Screw
3 Belt pulley
4 Coolant pump
5 Bolt
6 Bolt
8 Bolt
9 Connecting piece
10 Gasket
11 Crankcase ventilation
12 Connection fitting
13 Connector plug (from electrical engine wiring harness)
14 Gasket
15 Coolant thermostat
16 Coolant line
17 Banjo bolt
18 Coolant line
20 Coolant hose
21 Bracket
Modification notes
| Remove/install | ||
Danger! | Risk of injury to skin and eyes caused by scalding from contact with hot coolant spray. Risk of poisoning caused by swallowing coolant. | Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. Wear protective gloves, protective clothing and safety glasses. | |
| Notes on coolant | ||
1 | Drain coolant | Collect coolant | |
| Replace coolant | ||
2 | Remove coolant thermostat (15) | ||
3 | Undo bolts (2) at belt pulley (3) | ||
4 | Remove poly-V belt (1) | ||
5 | Remove belt pulley (3) | | |
6 | Remove bracket (21) at charge air pipe and coolant pump (4) | | |
7 | Remove connector plug (13) on coolant temperature sensor | ||
8 | Remove connection piece (9) | ||
| |||
9 | Remove connection fitting (12) | Installation: Replace connector fitting (12). | |
10 | Detach coolant hose (20) at coolant pump (4) | Collect coolant that flows out | |
11 | Detach coolant line (16) at coolant pump (4) | Collect coolant that flows out | |
Installation: Replace sealing rings. | |||
12 | Remove coolant pump (4) and remove gasket (14) | Installation: Replace seal (14). | |
| |||
13 | Install in the reverse order |
Coolant pump, coolant thermostat