AR14.40-W-2013A | Remove/install fill level and SCR AdBlue temperature combination sensor | 21.2.07 |
ENGINE 541.9 in MODEL 930, 932, 933, 934 with CODE (MS4) BlueTec 4
ENGINE 541.9 in MODEL 930, 932, 933, 934 with CODE (MS5) BlueTec 5
ENGINE 542.9 in MODEL 930, 932, 934 with CODE (MS4) BlueTec 4
ENGINE 542.9 in MODEL 930, 932, 934 with CODE (MS5) BlueTec 5
W14.40-1013-06
1 Electrical line
2 Electrical connector
3 Temperature sensor
4 O-ring
5 Spacer sleeve
6 Cable tie
7 AdBlue tank
B117 Fill level and SCR AdBlue temperature combination sensor
| Remove/install | ||
| Notes on use, material properties and handling of AdBlue | ||
1 | Switch off ignition | ||
2 | Disconnect electrical connector (2) | ||
3 | Remove cable tie (6) and spacer sleeve (5) | Installation: Replace removed cable tie. | |
4 | Pull electrical line (1) out of frame | ||
Danger! | Risk of burn injuries and scalding when working at AdBlue lines and the components attached to them. Risk of injury to skin and eyes when handling AdBlue. Risk of poisoning from swallowing AdBlue | Only pour AdBlue into suitable containers. Only begin work on the exhaust aftertreatment system after releasing the pressure. | |
5 | Remove the fill level and SCR AdBlue temperature combination sensor (B117) at the AdBlue tank (7) | If AdBlue drops come into contact with the AdBlue tank (7), the formation of urea crystals can be removed with water and a cleaning cloth. | |
6 | Install in the reverse order |