MODEL | 207 with ENGINE 271, 272, 273, 276, 642, 651 |
without CODE 211 (Direct-Steer system) |
Vehicle with engine 271 |
1 | Cap |
1a | Dipstick |
2 | Expansion reservoir |
3 | Engine air intake duct |
P46.00-2149-11
Vehicle with engine 272, 273 |
1 | Cap |
1a | Dipstick |
2 | Expansion reservoir |
3 | Engine air intake duct |
P46.00-2145-11
Vehicle with engine 276 |
1 | Cap |
1a | Dipstick |
2 | Expansion reservoir |
P46.00-2165-11
Vehicle with engine 642 |
1 | Cap |
1a | Dipstick |
2 | Expansion reservoir |
P46.00-2134-11
Vehicle with engine 651 |
1 | Cap |
1a | Dipstick |
2 | Expansion reservoir |
P46.00-2144-11
| Remove | ||
Danger ! | Risk of injury to skin or eyes from hydraulic fluid spraying out under pressure.Risk of poisoning from swallowing hydraulic fluid. | Depressurize hydraulic system completely before starting any work on it. Wear protective clothing and safety glasses. | |
1 | Switch off ignition | ||
2 | Open engine hood | ||
| |||
3.1 | Remove left engine intake air duct (3) | Engine 272, 273 | |
3.2 | Remove upper engine cover | ENGINE 642, 651 | |
Place upper engine cover onto padded base. | |||
3.3 | Remove front engine cover | Engine 276 | |
Place front engine cover on a padded base. | |||
4 | Remove cap (1) of power steering expansion reservoir (2) | The area around the separating point must be cleaned thoroughly before the hydraulic system of the power steering is cleaned. | |
Press the cap (1) downwards and turn counterclockwise through 90°. | |||
5 | Wipe off oil dipstick (1a) with a fluff-free rag and seal the expansion reservoir (2) with cap (1) | Press the cap (1) downwards and turn clockwise through 90°. | |
| Check | ||
6 | Remove cap (1) and read off oil level on oil dipstick (1a) | Observe oil temperature and markings on oil dipstick (1a). The oil level must be between the "MIN" and "MAX" markings which correspond to the oil temperature. | |
In order to avoid measurement errors, hold the oil dipstick (1a) upright. | |||
If the oil level is too low: | |||
| |||
Determine and rectify cause, subject to separate repair order. | |||
| Install | ||
7 | Seal expansion reservoir (2) with cap (1) | ||
8.1 | Install left engine intake air duct (3) | Engine 272, 273 | |
8.2 | Install upper engine cover | ENGINE 642, 651 | |
8.3 | Fit front engine cover | Engine 276 | |
9 | Close engine hood | ||
|