Shown on model 906.633 with rear axle 741.412 |
1 | Spring clip |
2 | Spring plate |
19 | Nut |
D35.10-1111-06
Danger ! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Danger ! | Risk of injury caused by pinching or crushing when working on springs or spring bodies that are under tension | Use only approved tensioning devices; additionally screen off hazardous area if necessary. Check special tools for damage and proper operation (visual inspection). Wear protective gloves. | |
Retightening | |||
1 | Lift/jack up vehicle | ||
| Lift/jack up vehicle | ||
2 | Mark design position of nut (19) relative to the spring saddle | Each nut (19) must be tightened individually in sequence. The nuts must not all be released at the same time. | |
3 | Loosen nut (19) by 45° | The static friction is thus overcome and the friction influence is reduced. | |
4 | Tighten nut (19) | In the process the nut (19) must at least reach the marked design position. If this is not the case, the specified torque may be exceeded. Solely maintaining the specified value is not permissible. | |
Spring U-bolt on rear axle spring to rear axle |