Modification notes |
12.03.2019 | In the case of maintenance steps for "Allow the engine to warm up", the information "Engine oil temperature 90 °C" is replaced by "Coolant temperature at least 80 °C". | ||
27.04.2020 | Oil filter cover to oil pan | Engine 177 in model 093, 192, 205, 213, 214, 217, 222, 223, 231, 232, 253, 290 | BA01.45-P-1002-01Y |
Shown on model 213.088 |
1 | Oil filter cover |
2 | Oil filter element |
3 | Sealing ring |
15 | Drain screw |
P18.00-2440-06
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Caution | Risk of injury to skin and eyes due to handling of engine oil. Risk of poisoning caused by swallowing engine oil | Wear protective gloves, protective clothing and safety glasses. | |
Topical note | Notes on engine oil and filter changes | ||
| Remove | ||
1 | Run engine to warm it up. | Coolant temperature at least 80 °C. | |
2 | Switch off engine. | ||
3 | Remove center engine compartment lining. | ||
| Model 213 | ||
| Model 217, 222 | ||
| Model 290 | ||
4 | Unscrew drain screw (15) and drain engine oil. | Dispose of drain screw (15). | |
5 | Unscrew oil filter cover (1). | Unscrew oil filter cover (1) far enough from oil filter housing so that engine oil can drain out of oil filter and oil filter housing. | |
6 | Remove oil filter cover (1). | ||
| Install | ||
7 | Replace oil filter element (2). | ||
8 | Replace sealing ring (3). | ||
9 | Tighten oil filter cover (1). | Oil filter cover to oil pan | |
10 | Screw in new drain screw (15). | Plastic drain screw to oil pan bottom section | |
11 | Install center engine compartment lining. | ||
| Model 213 | ||
| Model 217, 222 | ||
| Model 290 | ||
12 | Add engine oil. | | |
Engine oil filling capacity (oil change and filter change) | |||
| Check | ||
13 | Run engine until warm and check for leak tightness. | Coolant temperature at least 80 °C. | |
If fluid loss occurs, | |||
| |||
determine cause and correct. | |||
After obtaining special order. | |||
14 | Check engine oil level using instrument cluster, correct if necessary. |