ar4630p0010sx

Fill power steering pump and bleed

Tip ar · temă 46.30 · versiune 0203 · 2011-03-22

Valabil pentru: MODEL 221.0 /1, 216

Nu este disponibil în „ro”; afișat în Engleză.

Încadrare

Grupă funcțională 2 Sistem de rulare › 46 Direcţie › 46.30 Pompă de servodirecţie — Seria 216 · Seria 221 (modele 0**, 1**)

EinPAS 22 Direcţie › 22.15 Servodirecţie › 22.15.31 Pompă servodirecţie/Rezervor ulei/Filtru — Seria 216 · Seria 221 (modele 0**, 1**)

AR46.30-P-0010SX

Fill power steering pump and bleed

16.3.11

MODEL 221.0 /1, 216

Fill power steering pump and bleed

P46.30-2218-05

Shown on model 221.056 with AIRmatic

1 Left engine air intake duct

2 Power steering expansion reservoir

Fill power steering pump and bleed

P46.25-2173-11

Vehicles with electrohydraulic power steering (EHPS), shown on model 221.095

2 Power steering expansion reservoir

Modification notes

23.4.06

Document adapted to the revised procedure

Remove/install

Danger!

Risk of injury to skin or eyes caused by hydraulic fluid spraying out under high pressure. Risk of poisoning caused by swallowing hydraulic fluid

Depressurize the hydraulic system completely before starting any work on the system. Wear protective clothing and safety glasses.

AS00.00-Z-0013-01A

Danger!

Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof

Keep body parts and limbs well clear of moving parts.

AS00.00-Z-0011-01A

1

Hoist vehicle with lifting platform until wheels are free

2.1

Remove left engine intake air duct (1)

Vehicles with gasoline engine without electrohydraulic power steering (EHPS) and without code (487) Active Body Control (ABC)

2.2

Remove engine trim panel

Engine 642

AR01.10-P-2405SXI

3

Remove cap from expansion reservoir (2)

Fill

4

Fill expansion reservoir (2) with MB steering gear oil

Do not start the engine!

If the engine is started there is a risk of air entering the hydraulic steering system, which is then extremely difficult to remove.

Fill the expansion reservoir (2) to approx. 10 mm below the upper edge of the reservoir with MB steering gear oil.

Refill with MB-steering gear oil continuously until the oil level remains constant.

*BF46.20-P-1001-01A

Bleeding

5

Turn steering wheel from steering stop to steering stop

Do not start the engine!

If the engine is started there is a risk of air entering the hydraulic steering system, which is then extremely difficult to remove.

Turn steering wheel slowly from steering stop to steering stop until bubbles are no longer visible in the expansion reservoir (2).

Repeat turning the steering from stop to stop several times (up to 30 times). During this process, MB steering gear oil must be poured into the expansion reservoir (2) by a second person.

Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running

Secure vehicle to prevent it from moving by itself.
Wear closed and snug-fitting work clothes.
Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

6

Start engine without moving the steering

Allow engine to run for approx. 1 min. at idle speed.

During this process, a second person must observe the oil level in the expansion reservoir (2) and add MB steering gear oil if necessary.

7

Turn steering wheel from steering stop to steering stop

When the engine is running turn the steering wheel slowly several times from steering stop to steering stop, meanwhile adding MB steering gear oil in expansion reservoir (2).

Repeat the procedure until the oil level in the expansion reservoir (2) remains constant and bubbles are no longer visible.

Checking

8

Check oil level in the expansion reservoir (2) and fill up to the maximum fill level

The oil level in the expansion reservoir (2) must always be filled up to the maximum.

Power steering - checking and correcting oil level

AP46.00-P-4611SX

9

Check steering system when engine is running for signs of leaks and proper function

In the event of leakage, find and eliminate cause.

10

Install in the reverse order

Steering gear

Number

Designation

Model
216

Model
221

BF46.20-P-1001-01A

Power steering

Filling capacity

Liters

1,0

1,0

MB steering gear oil

Sheet

BB00.40-P-0345-00A

BB00.40-P-0345-00A

Documente menționate