AP83.00-T-8352AA | Air conditioning system - function check | 6.12.02 |
MODELS NMB671.015 /020 /021 /030 /042 with CODE (HKA) Konvekta ACX 602 air conditioning with roof heater
T83.00-0049-11
1 Blower rotary switch
2 "AC" indicator lamp
3 AC operation switch
4 Recirculated air/fresh air/mixed air operation switch
5 "Smog" indicator lamp
6 Control knob
T83.00-0050-01
7 Hub
Condenser blower (arrows)
T83.00-0051-01
T83.00-0052-08
8 Breaks
9 Air flaps
T83.00-0053-11
10 Shutoff valve
Inspect | |||
Danger! | Risk of accident as vehicle may start off by itself with the engine running. Risk of injury as working around the engine during start-up or while running may result in contusions and burns | Secure vehicle to prevent it from moving. | |
Danger! | Lethal Hazard from being drawn into rotating vehicle parts | Do not reach into rotating parts. | |
| Function check of air conditioning for its cooling capacity is only possible if the temperature in the passenger compartment is above 17 °C | ||
1 | Start engine | Coolant temperature of min. 50 °C must be ensured. | |
2 | Turn blower rotary switch (1) to stage 1 | ||
3 | Press AC operation switch (3) | The AC indicator lamp (2) must illuminate. A temperature control by the roof AC is only ensured if the AC operation switch (3) is pressed. | |
| Check refrigerant compressor | ||
4 | Turn rotary knob (6) for "Passenger compartment temperature" to the left as far as possible | ||
5 | Open tailgate at rear | ||
6 | Perform visual inspection of refrigerant compressor | If the engine is running and the air conditioning is switched on, the hub (7) must rotate. | |
| Check condenser blower | ||
7 | Perform visual inspection of condenser blowers (arrows) | For operations in the roof area, the accident prevention regulations must be observed | |
The condenser blowers (arrows) must rotate when the air conditioning is switched on. | |||
| Check passenger compartment cooling capacity | ||
8 | Remove headliner | Only in the left-hand and right-hand area of the recirculating air filter. | |
| Remove/install headliner | ||
9 | Using the temperature measuring equipment sensor, measure the temperature of the air flowing out of the openings (8) | The temperature of the air flowing out after operating for approx. five minutes must be significantly below the outside temperature. Otherwise the leaktightness of the air conditioning must be checked: | |
| Checking air conditioning system for leakage | ||
| |||
Check passenger compartment radial blower | |||
10 | Turn blower rotary switch (1) from stage 1 to stage 2 and then to stage 3 | The blower capacity of the radial blower must audibly increase significantly. | |
11 | Compare the air flowing out at the openings (8) | If the force of the air flowing out is unequal: | |
Check radial blower for proper operation. | |||
| Check passenger compartment recirculated air flaps | ||
12 | Remove recirculating air filter | ||
13 | Press switch (4) for "Passenger compartment recirculated air" and check position of air flaps (9) | See operating instructions for Konvekta | |
The Smog indicator lamp (5) must light up, and the air flaps (9) must be open. | |||
14 | Press switch (4) for "Passenger compartment fresh air" and check position of air flaps (9) | The Smog indicator lamp (5) must go out, and the air flaps (9) must be closed. | |
15 | Press switch (4) for "Passenger compartment mixed air" and check position of air flaps (9) | The air flaps (9) must be in the center position. | |
| Check passenger compartment roof heater | ||
16 | Turn rotary knob (6) for "Passenger compartment temperature" to the right as far as possible | ||
17 | After a waiting time of approx. 3 minutes check whether the shutoff valve (10) heats up | ||
18 | Using the temperature measuring equipment sensor, measure the temperature of the air flowing out of the openings (8) | Warm air must come out of the openings (8) on the left-hand and right-hand vehicle side. | |
| |||
19 | Install recirculating air filter | ||
20 | Install headliner | ||
| Remove/install headliner | ||
21 | Switch off engine | ||
22 | Close tailgate at rear |
Commercially available tools
Documente menționate
- ap8310t8383aa
- ar6830t4300aa
- ar8330t120901c
- as0000z000401a Pericol de moarte prin prinderea în componentele autovehicului aflate în rotaţie
- as0000z000501a Pericol de accident prin pornirea de pe loc cu motorul aflat în funcţionare. Pericol de rănire prin striviri şi arsuri la manipularea în timpul pornirii motorului sau cu motorul aflat în funcţionare