ap5400d545101a

Checking indicator lamps

Tip ap · temă 54.00 · versiune 0401 · 2011-08-29

Valabil pentru: MODEL 901, 902, 903, 904, 905, 690.6 MODEL WD1, WD2, WD3, WD6, WD7, XD1, XD2, XD3, XD4, XD5, XD6, XD7, YD1, YD2, YD3, YD4, YD5, YD6, YD7

Nu este disponibil în „ro”; afișat în Engleză.

Încadrare

Grupă funcțională 2 Sistem de rulare › 54 Instalaţie electrică, echipament şi instrumente › 54.00 Generalităţi — Seria 690 (modele 6**) · Seria 901 · Seria 902 · Seria 903 · Seria 904 · Seria 905

EinPAS 31 Comunicaţie/Informaţie/Entertainment › 31.30 Kombiinstrument/Calculator de bord › 31.30.15 Afişaj display — Seria 690 (modele 6**) · Seria 901 · Seria 902 · Seria 903 · Seria 904 · Seria 905

EinPAS 31 Comunicaţie/Informaţie/Entertainment › 31.50 Display › 31.50.15 Afişaj display — Seria 690 (modele 6**) · Seria 901 · Seria 902 · Seria 903 · Seria 904 · Seria 905

AP54.00-D-5451-01A

Checking indicator lamps

Model 901, 902, 903, 904, 905, 690.6

Checking indicator lamps

N54.00-2088-02

1 Operate parking brake , turn ignition lock into driving position.
The following indicator lamps, where installed, must be on:
Preglow (diesel engines) (1)
immobilizer (gasoline engines) (2)
battery charge (3)
engine oil pressure (4)
brake fluid level/brake lining wear (5)
parking brake (6)
coolant level (7)
antilock brake system (ABS) (8)
automatic brake differential (ABD) (9)
working speed control (ADR) (10)
Electronic Diesel Control (EDC) (11)
supplemental restraint system (SRS) (12)
fuel reserve

Fuel filter clogged

Water in fuel filter

-----------------------------------------------------------------------------------------

After a few seconds the following indicator lamps go out:
Immobilizer (gasoline engines) (2)
antilock brake system (ABS) (8)
automatic brake differential (ABD) (9)
working speed control (ADR) (10)
Electronic Diesel Control (EDC) (11)
supplemental restraint system (SRS) (12)
fuel reserve

After reaching the required start temperature, the preglow (diesel engines) indicator lamp (1) goes out.

If a system error occurs the relevant indicator lamp comes on and stays on or the error is displayed in the display (on-board computer).

-----------------------------------------------------------------------------------------

2 Start engine.

All indicator lamp except the parking brake (6) must go out.

3 Check all other indicator lamps.
Switch the relevant mode switches on and off or switch the relevant equipment on and off.
For example:
Turn signal lights (13)
hazard warning system
high beams (14)
tipper control (15)
power take-off (16)
rear-axle differential lock (17)

4 Switch off engine.