ad4245p4000a

Electronic stability program (ESP), BAS and SPS diagnosis, fault memory

Tip ad · temă 42.45 · versiune 0109 · 2004-06-01

Valabil pentru: MODEL 202 with ENGINE 112, 113 with CODE (472a) Electronic Stability Program (ESP) MODEL 129, 208 with ENGINE 112, 113 with CODE (472a) Electronic Stability Program (ESP) MODEL 210 with ENGINE 111, 112, 113, 605, 606, 611, 612, 613 with CODE (472a) Electronic Stability Program (ESP)

Nu este disponibil în „ro”; afișat în Engleză.

Încadrare

Grupă funcțională 2 Sistem de rulare › 42 Sistem hidraulic frâne şi sistem mecanic › 42.45 Electronic Stability Program (ESP), sistem de reglare a stabilităţii (SR) — Seria 129 · Seria 202 · Seria 208 · Seria 210 · Seria 611 · Seria 613

Valabil și pentru motoare/cutii de viteze: 111 ***, 112 ***, 113 ***, 605 ***, 606 ***, 612 ***

AD42.45-P-4000A

Electronic stability program (ESP), BAS and SPS diagnosis, fault memory

MODEL 202 with ENGINE 112, 113 with CODE (472a) Electronic Stability Program (ESP)

MODEL 129, 208 with ENGINE 112, 113 with CODE (472a) Electronic Stability Program (ESP)

MODEL 210 with ENGINE 111, 112, 113, 605, 606, 611, 612, 613 with CODE (472a) Electronic Stability Program (ESP)

Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between the pillars of the lifting platform and position the four support plates at the lifting platform mounting points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

Electronic stability program (ESP), BAS and SPS diagnosis, advanced information

AD42.45-P-2000A

Connect handheld tester (HHT) and read out DTC memory

AD00.00-P-2003A

Ignition: ON

Read out fault memory of ESP, BAS, ME-SFI and ETC systems

Control unit initialization

Reconfiguration of the control unit (N47-5) is essential after replacing the ESP control unit (N47-5) or the brake booster (A7/7).

The values for the BAS solenoid valve must be read into the ESP control unit (N47-5).

See HHT menu

Fault memory

Fault code

Fault text

Possible cause / Note

Remedy

No fault

In the event of a complaint carry out testing electrical system of ESP and SPS in full

AD42.45-P-6000A

ESP control unit (N47-5)

Reconfigure control units after replacing parts

N47-5

ESP control unit (N47-5) BAS computer defective

Reconfigure control units after replacing parts

N47-5

Battery undervoltage, terminal 87

AD42.45-P-6000-01A

Solenoid valve voltage supply, open circuit or short circuit

AD42.45-P-6000-01B

AD42.45-P-6000-17A

Battery overvoltage, terminal 87

AD42.45-P-6000-01A

Fault in CAN communication in general

AD42.45-P-6000-35A

CAN communication with right control unit (ME-SFI) (N3/12) faulty

AD42.45-P-6000-35A

Read ME-SFI fault memory.

Check ME-SFI coding (HHT).

CAN communication with BAS control unit faulty

Reconfigure control units after replacing parts

N47-5

Left front rpm sensor (L6/1), open circuit

Left front rpm sensor (L6/1), loose contact

Left front rpm sensor (L6/1), plausibility

Rotor with incorrect number of teeth, dirty or damaged, incorrect rear axle ratio, tires or wheels.

AD42.45-P-6000-08A

Right front rpm sensor (L6/2), open circuit

Right front rpm sensor (L6/2), loose contact

Right front rpm sensor (L6/2), plausibility

Rotor with incorrect number of teeth, dirty or damaged, incorrect rear axle ratio, tires or wheels.

AD42.45-P-6000-10A

Left rear rpm sensor (L6/3), open circuit

Left rear rpm sensor (L6/3), loose contact

Left rear rpm sensor (L6/3), plausibility

Rotor with incorrect number of teeth, dirty or damaged, incorrect rear axle ratio, tires or wheels.

AD42.45-P-6000-12A

Right rear rpm sensor (L6/4), open circuit

Right rear rpm sensor (L6/4), loose contact

Right rear rpm sensor (L6/4), plausibility

Rotor with incorrect number of teeth, dirty or damaged, incorrect rear axle ratio, tires or wheels.

AD42.45-P-6000-14A

ESP yaw rate sensor (N64)

Model 168 until 7/99

Model 202 with M112, 113, 604

Model 208 with M112, 113

Model 210 with M111, 112, 113, 604, 605, 606

AD42.45-P-6000-32A

Yaw speed and lateral acceleration sensor (B24/15),

Yaw rate signal cable open circuit/short circuit

Model 168 applicable as of 8/99

Model 210 with M611, 612, 613

AD42.45-P-6000-39A

Steering angle sensor (N49), open-circuit/short-circuit

Steering angle sensor, initialization

AD42.45-P-6000-06A

Turn steering wheel clockwise and anti-clockwise up to the stops

ESP brake pressure sensor (B34) open/short circuit

ESP brake pressure sensor (B34) plausibility

AD42.45-P-6000-31A

Lateral acceleration sensor (B24/2)

Model 168 until 7/99

Model 202 with M112, 113, 604

Model 208 with M112, 113

Model 210 with M111, 112, 113, 604, 605, 606

AD42.45-P-6000-30A

Yaw speed and lateral acceleration sensor (B24/15),

Open/short circuit, voltage supply, plausibility

Model 168 applicable as of 8/99

Model 210 with M611, 612, 613

AD42.45-P-6000-39A

Voltage supply

ESP brake pressure sensor (B34),

Diaphragm travel sensor (A7/7b1),

AD42.45-P-6000-31A,

AD42.45-P-6000-33A,

Lateral acceleration sensor (B24/2)

Model 168 until 7/99

Model 202 with M112, 113, 604

Model 208 with M112, 113

Model 210 with M111, 112, 113, 604, 605, 606

AD42.45-P-6000-30A

Yaw rate and lateral acceleration sensor (B24/15)

Model 168 applicable as of 8/99

Model 210 with M611, 612, 613

AD42.45-P-6000-39A

Stop light switch (S9/1), membrane travel comparison plausibility

Stop light switch (S9/1), plausibility

Cable

S9/1

BAS release switch (A7/7s1), open-circuit/short circuit

BAS release switch (A7/7s1), plausibility

BAS release switch (A7/7s1), redundancy, changeover time

Reconfigure control units after replacing parts

Cable

A7/7s1

BAS diaphragm travel sensor (A7/7b1), diaphragm speed

BAS diaphragm travel sensor (A7/7b1), plausibility

BAS diaphragm travel sensor (A7/7b1), open circuit

BAS diaphragm travel sensor (A7/7b1), cable short-circuit to ground

AD42.45-P-6000-33A

Left front pressure hold solenoid valve (A7/3y6), open-circuit/short-circuit

AD42.45-P-6000-18A

Left front pressure reduction solenoid valve (A7/3y7), open/short circuit

AD42.45-P-6000-19A

Right front pressure hold solenoid valve (A7/3y8), open/short circuit

AD42.45-P-6000-20A

Right front pressure reduction solenoid valve (A7/3y9), open/short circuit

AD42.45-P-6000-21A

Left rear pressure hold solenoid valve (A7/3y10), open-circuit/short-circuit

AD42.45-P-6000-22A

Left rear axle solenoid valve (release) (A7/3y11), open-circuit / short-circuit

AD42.45-P-6000-23A

Right rear axle solenoid valve (hold) (A7/3y12), open-circuit / short-circuit

AD42.45-P-6000-24A

Left rear pressure reduction solenoid valve (A7/3y13), open/short circuit

AD42.45-P-6000-25A

Front axle inlet solenoid valve (A7/3y22), open-circuit / short-circuit

AD42.45-P-6000-26A

Rear axle inlet solenoid valve (A7/3y23), open-circuit / short-circuit

AD42.45-P-6000-27A

Front axle switchover solenoid valve (A7/3y18), open-circuit / short-circuit

AD42.45-P-6000-28A

Rear axle switchover solenoid valve (A7/3y19), open-circuit / short-circuit

AD42.45-P-6000-29A

BAS solenoid valve (A7/7y1), open-circuit/short circuit

Reconfigure control units after replacing parts

AD42.45-P-6000-34A

High pressure/return flow pump (A7/3m1), open/short circuit

High-pressure/return pump (A7/3m1) fails to switch off

High pressure/return flow pump (A7/3m1), stops too soon

AD42.45-P-6000-04A

BAS brake servo (A7/7) defective

BAS brake servo, diaphragm travel sensor (A7/7b1) or solenoid valve (A7/7y1) defective

Reconfigure control units after replacing parts

A7/7

AD42.45-P-6000-33A

AD42.45-P-6000-34A

Rpm sensor plausibility

Rotor with wrong number of teeth or dirty or damaged, wrong rear final drive ratio or tires or wheels.

AD42.45-P-6000-08A AD42.45-P-6000-10A AD42.45-P-6000-12A AD42.45-P-6000-14A

SPS P-valve (Y10)

AD42.45-P-6000-05A

System has switched off

Steering angle not initialized,

Brake pressure sensor(B34)

Turn steering wheel clockwise and anti-clockwise up to the stops

AD42.45-P-6000-31A

Yaw rate sensor (N64)

Model 168 until 7/99

Model 202 with M112, 113, 604

Model 208 with M112, 113

Model 210 with M111, 112, 113, 604, 605, 606

AD42.45-P-6000-32A

Yaw speed and lateral acceleration sensor (B24/15),

Undervoltage

Model 168 applicable as of 8/99

Model 210 with M611, 612, 613

AD42.45-P-6000-39A

Engine control unit wrongly coded

Code ME control unit

Road test not carried out.

Carry out road test

Model 168 as of 01.03.99 with Code (472a)

Models 202, 208, 210 as of 01.06.00 with CODE (472a)

AD42.45-P-3000-01A

Documente menționate