Remove/install engine hood

AR88.40-D-3000TS

Remove/install engine hood

15.03.2019

Model

907, 910

Modification notes

13.03.2019

Factual information and WIS Service Media link added

Operation step 8

1

Engine hood

2

Hinges

3

Bolts

 Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A



Remove

1

Mark installation position of the hinges (2) on the hood (1).

If the hood (1) is reused.

2

Remove air inlet grilles from the hood (1).

AR88.40-D-3001TS

3

Remove hood (1).

 To do this, remove screws/bolts (3).

 Helper required.

4

Disassemble hood (1).

If a new hood (1) is installed.

AR88.40-D-3002TS



Install

5

Perform cavity preservation process for hood (1).

If a new hood (1) is installed.

AR97.20-D-1500TS

6

Assemble new hood (1).

If a new hood (1) is installed.

AR88.40-D-3002TS

 Do not install hood (1) yet.

7

Install hood (1).

 Screw in bolts (3) to do this.

 Helper required.

 Screw/bolt, engine hood to hinge

*BA88.40-N-1001-01TS

If the hood (1) is reused,



Observe installation position of hinges (2).

8

Adjust engine hood (1).

AR88.40-D-3020TS


Check that the installation position of the hood (1) is correct.
An incorrect installation position will cause damage to the front fenders and hood (1) when the hood (1) is closed.

 WIS Service Media
wsm://04_ 201900_37

 Engine hood

Number

Designation

Model 907, 910

BA88.40-N-1001-01TS

Screw/bolt, engine hood to hinge

Nm

21