Remove/install engine hood · ar8840d3000ts · Mercedes-Benz WIS

AR88.40-D-3000TS

Remove/install engine hood

15.03.2019

Model

907, 910

Modification notes

13.03.2019

Factual information and WIS Service Media link added

Operation step 8

D88.40-1129-06

 Warning	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Remove
1	Mark installation position of the hinges (2) on the hood (1).	If the hood (1) is reused.
2	Remove air inlet grilles from the hood (1).		AR88.40-D-3001TS
3	Remove hood (1).	 To do this, remove screws/bolts (3).
		 Helper required.
4	Disassemble hood (1).	If a new hood (1) is installed.
			AR88.40-D-3002TS
	Install
5	Perform cavity preservation process for hood (1).	If a new hood (1) is installed.
			AR97.20-D-1500TS
6	Assemble new hood (1).	If a new hood (1) is installed.
			AR88.40-D-3002TS
		 Do not install hood (1) yet.
7	Install hood (1).	 Screw in bolts (3) to do this.
		 Helper required.
		 Screw/bolt, engine hood to hinge	*BA88.40-N-1001-01TS
		If the hood (1) is reused,
		
		Observe installation position of hinges (2).
8	Adjust engine hood (1).		AR88.40-D-3020TS
		 Check that the installation position of the hood (1) is correct. An incorrect installation position will cause damage to the front fenders and hood (1) when the hood (1) is closed.
		 WIS Service Media wsm://04_ 201900_37

 Engine hood

Number	Designation		Model 907, 910
BA88.40-N-1001-01TS	Screw/bolt, engine hood to hinge	Nm	21

ar8840d3001ts Remove/install air inlet grille on engine hood
ar8840d3002ts Disassemble/assemble engine hood
ar8840d3020ts Adjust engine hood
ar9720d1500ts Cavity preservation following repair work
as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.