Remove/install D-pillar trim

AR68.30-D-4497TSR

Remove/install D-pillar trim

13.06.2019

Model

907.6/7/8

Shown on model 907.7

1

D-pillar paneling

2

Expansion rivets (5 pcs.)

3

Electrical connector

Shown on model 907.7

1

D-pillar paneling

4

Mounting clip

5

12V socket

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

 

Remove/install

1

Remove left or right grab handle from D-pillar.

Model 907.6/7
with code T85 (Entrance handle on LH rear corner pillar)
Model 907.6/7
with code T86 (Entrance handle on RH rear corner pillar)

2

Remove expansion rivets (2).

3

Unclip D-pillar trim (1) from top to bottom until electrical connector (3) is accessible.

If installed.

 Long wedge

*115589035900

4

Disconnect electrical connector (3) from 12 V socket (5) and remove D-pillar trim (1) to the rear.

If installed.

5

Remove 12 V socket (5) from D-pillar trim (1).

If installed when installing new D-pillar trim (1).

AR54.10-D-1009TS



Check

6

Check retaining clips (4) for damage and correct seating.

If a retaining clip (4) is not correctly positioned in mount on D-pillar trim (1),



Correctly position retaining clip (4).

If a retaining clip (4) is damaged,



Replace retaining clip (4).

7

Install in the reverse order



Check

8

Perform function test of the 12 V socket (5).

If installed.