ar4110p008604msa

Correcting center inclination angle at propeller shaft intermediate bearing

Typ ar · temat 41.10 · wersja 0100 · 2018-02-02

Dotyczy: Model 257

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 2 Podwozie › 41 Wał napędowy › 41.10 Wał napędowy — Seria 257

EinPAS 17 Zespół przeniesienia napędu/ oś › 17.40 Wał napędowy › 17.40.30 Wał napędowy napędu/ napędu na cztery koła — Seria 257

AR41.10-P-0086-04MSA

Correcting center inclination angle at propeller shaft intermediate bearing

Model

257

Check values for propeller shaft articulation angle

Number

Designation

Model 257
Except AMG

Model 257
AMG

BE41.10-P-1002-01G

Inclination angle of front propeller shaft relative to rear propeller shaft (2)

°

+0,00...+1,00

+0,70…+1,30

Propeller shaft intermediate bearing

Number

Designation

Model 257

BA41.40-P-1001-01H

Bolt, propeller shaft intermediate bearing to frame floor assembly

Nm

25

Correct inclination angle at the center (2).

To correct the inclination angle, install shop-made spacers at the propeller shaft intermediate bearing. A 1 mm thick spacer changes the inclination angle by approx. 0.17°.
When using spacers > 2 mm thick, the bolt length has to be increased by 5 mm.
If a spacer > 5 mm thick is required, check the front engine mount and rear engine mount for signs of settling or wear and replace if necessary.

Correcting center inclination angle at propeller shaft intermediate bearing

1

Mark the propeller shaft intermediate bearing.


Apply color markings identifying the position of the propeller shaft intermediate bearing relative to the frame floor assembly, in order to reproduce the plant installation position when installing.



2

Remove bolt (7a) from propeller shaft intermediate bearing.



3

Insert shop-made spacers between the frame floor assembly and propeller shaft intermediate bearing. 


The dimensions for the spacers must be taken at the propeller shaft intermediate bearing, see following picture.



4

Tighten screws/bolts (7a) from propeller shaft intermediate bearing   .


P41.40-2010-01

Correcting center inclination angle at propeller shaft intermediate bearing

Example:
Spacers (c) between frame floor assembly and propeller shaft intermediate bearing.
Material: steel or aluminum.

P41.10-2157-01