| Measuring and adjusting | ||
1 | Move the vehicle to the measuring station. | The measuring system must be approved by Mercedes-Benz | |
Abide by the general instructions for chassis alignment | |||
2 | Disconnect the rotating plates | ||
3 | Install brake pedal tensioning device in brake pedal | | |
4 | Install the Mercedes-Benz quick-release clamping holder | Install the value detector | |
5 | Carry out initial measurement | The real values of the relative magnitudes of the vehicle will be measured | |
6 | Measure the vehicle level on the front and rear axle | The toe-in, camber and caster will be adjusted with reference to the vehicle level | |
7 | Check and adjust the camber and toe-in on the rear axle | ||
8 | Check and adjust the camber and caster on front axle | ||
9 | Check and adjust toe-in on front axle | ||
10 | Carry out final alignment | Apart from a control measurement of the magnitudes or adjusted values, a check must be carried out especially on the toe-out on turns which is essential for the steering geometry | |
Check toe-out on turns | |||
11 | Remove the value detector | ||
12 | Remove the brake pedal tensioning device from the brake pedal | ||
13 | Take the vehicle out of the measuring station | . | |
14 | Lock the rotating plates |
000 589 18 31 00
Brake pedal winch