AR05.20-D-6010NB | Check basic position of camshafts | 4.9.03 |
ENGINE 647.981 in MODEL WD1, WD2, WD3, WD6, WD7, XD1, XD2, XD3, XD4, XD5, XD6, XD7, YD1, YD2, YD3, YD4, YD5, YD6, YD7
ENGINE 647.981 in MODEL 903.61 /66 /67, 904.61 /66 with CODE (ZU7) National version for Canada
ENGINE 647.981 in MODEL 903.61 /66 /67, 904.61 /66 with CODE (ZU8) National version for USA
ENGINE 647.981 in MODEL 903.61 /62 /66 /67, 904.61 /62 /66 with CODE (ZU9) National version for Mexico
D05.20-1113-06
1 Inlet camshaft
2 Exhaust camshaft
3 Locking pin
A Locking hole
B Markings
| Remove/Install | ||
1 | Remove cylinder head cover | ||
2 | Position piston of cylinder 1 to ignition TDC | Crank engine at crankshaft in clockwise direction to TDC marking (arrows). Do not crank engine backwards and not at the intake camshaft (1) and exhaust camshaft (2), otherwise this can lead to damage at the engine control or at the intake camshaft (1) and the exhaust camshaft (2). The cams of the intake camshaft (1) and exhaust camshaft (2) for 1st cylinder must point upwards. | |
3 | Lock inlet camshaft (1) with retaining | Insert retaining pin (3) at 1st camshaft bearing cap into the locking hole (A) into the camshaft sprocket of the intake camshaft (1). | |
| |||
| Check | ||
4 | Check basic position of camshafts | Both markings (B) in the camshaft sprockets of the intake camshaft (1) and exhaust camshaft (2) must be positioned opposite each other. Also the markings of the intake camshaft (1) and exhaust camshaft (2) must align with the marking on the camshaft bearing cap (arrows). If necessary after checking: | |
Correct basic position of the camshafts. | |||
5 | Install in the reverse order |
Retaining pins
111 589 03 15 00