P97.20-0200-09
1 Engine hood
2 Trunk lid
5 Rear door-rubber retaining rail
6 Door channel, rear door
3 Driver's door-rubber retaining rail
4 Door channel, driver's door
P97.20-0202-09
Front end
7 Reinforcement-windbreak
8 A-pillar-longitudinal member, inner
12 Tunnel reinforcement
13 Spring tower
9 Fork retainer-front wall
10 Longitudinal member
11 Cross member
P97.20-0201-06
Front end Wheel house side member-floor assembly
14 A-pillar-wheel house
15 Longitudinal member, outer
16 Firewall reinforcement
17 Connecting carrier-wheel arch panel
18 Console-transverse link bearing, bottom
19 Engine support
P97.20-0203-09
Rear end
20 Rear end center assembly
21 Longitudinal member-wheel arch panel
24 Cross member-rear axle
25 Mounting
22 Longitudinal member, outer
23 Wheel house inner - rear fender
Fig. item, etc. | Work instructions | ||
Danger! | Risk of explosion and poisoning through solvent vapors and gases. Risk of injury to eyes and skin when handling anti-corrosion agents | Do not spray anti-corrosion agent into flames or onto glowing-hot surfaces and keep away from ignition sources. Work only in well ventilated areas, wear protective respiratory mask. | |
| Notes on hollow cavity preservation | ||
Processing instructions for hollow cavity preservation | |||
| Apply wax preservative on hatched areas only after sealing and painting work, but before assembly work. | Insert spray hose as far as possible into cavities and pull out slowly during spraying. | |
Spray hose must be stiff and jets must spray inclined to front and rear. Cavities must be dry. | |||
| Carry out repair preservation twice in succession after a flash-off time of 5 minutes. | Application temperature must not be below +15 °C. Apart from the standard cavity preservation as shown, additional sealing measures may be required depending on area of repair. |
참조 문서
- ah9720p000101b 틈새 실런트 관련 지침
- ap9720p064001a 틈새 실런트 작업 지침
- as9700z000101a 솔벤트 증기 및 가스에 의한 폭발 위험과 중독 위험 부식 방지제를 취급할 때 입을 수 있는 안구와 피부의 상해 위험