1 | Trim ring |
A | Range |
D61.10-0071-06
| Remove | ||
Warning | Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units. | Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply. | |
Topical note | Notes on performing repair, body work and welding on vehicles with airbags and RTE units | ||
Topical note | General information on body repair | ||
1 | Remove detachable parts in repair area | ||
2 | Cover all detachable parts that remain in the repair area | ||
3 | Expose and bore spot welds in area A. | ||
Bore the spot welds | |||
Spot weld milling cutter | |||
4 | Remove the trim ring (1) | ||
5 | Grind off the floor at the front (2), in the area of the trim ring (1), and coat it with zinc dust paint | Zinc dust paint suitable for spot welding | |
Zinc dust paint suitable for spot welding | |||
| Install | ||
6 | Attach holes (arrow), Ø 6 mm, with maximum hole interval of 30 mm, on the circumference of the trim ring (1) | Only when replacing the trim ring (1) | |
7 | Grind off both sides of the trim ring (1) in the area of the bored and attached holes and coat them with zinc dust paint | Zinc dust paint suitable for spot welding | |
Zinc dust paint suitable for spot welding | |||
8 | Fit and align the trim ring (1) | ||
9 | Weld trim ring (1) to front floor (arrow) | ||
Topical note | Measures for preventing damage to vehicles or components when performing electric welding work | ||
General notes on welding | |||
10 | Grind off any residue welding material | ||
11 | Clean areas repaired and priming with MB primer filler | ||
12 | Supplement standard seals with MB body sealant | ||
Seam seal after repair | |||
13 | Supplement standard underfloor protection with MB permanent underbody sealant | ||
14 | Paint repair area adjacent surfaces | ||
15 | Reinstall all detachable parts removed |
201 589 00 51 00
Spot weld milling cutter
참조 문서
- ah0000n000501a 전기 용접 작업 시 차량 또는 부품 손상 방지 조치
- ah6000n000101a 차체 정비 관련 일반 지침
- ah6000n000501a 일반 용접 지침
- ah9100p000201m 에어백 유닛 또는 안전벨트 텐셔너 유닛이 장착된 차량에서의 정비 작업, 차체 작업, 용접 작업 실행에 관한 지침
- ar6420d0002a
- ar9710d4000a
- as9100z000101d 에어백 유닛 혹은 안전벨트 텐셔너 유닛의 점검 작업 또는 정비 작업 중 상해 위험