P14.30-2150-06
1 Bracket
2 Bolt
3 Electrical connector
4 Ground cable
5 Air hose
M33 Electric air pump
| Remove/install | ||
Danger! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | When moving components, ensure that no body parts or limbs are within the operating range of moving parts. | |
1 | Open engine hood | ||
2 | Remove engine trim panel | ||
3 | Remove the bracket (1) of the electrical air pump (M33) by unscrewing the bolt (2) | Installation: Ensure the correct position and contact of the ground line (4). | |
| |||
4 | Remove air hose (5) from the electrical air pump (M33) | ||
5 | Disconnect the electrical connector (3) at the electric air pump (M33) | ||
6 | Take out electric air pump (M33) | ||
7 | Install in the reverse order | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near engine | Secure vehicle to prevent it from moving. | |
8 | Conduct engine test run and check the intake system for leaks | If a leak is found, determine the cause and rectify, otherwise engine malfunctions may result. |
Air pump
참조 문서
- ar0110p2405rt
- ar0110p2405rtb
- ar8840p1000rt 엔진 후드 열기, 수직으로 세우기, 닫기
- as0000z000501a 엔진이 작동 중인 상태에서 급발진에 의한 사고 위험 시동 또는 구동 중인 엔진 근처에서 작업할 때 차량에 부딪히거나 열에 의한 상해 위험
- as0000z001101a 후드, 도어, 커버, 슬라이딩 루프 탈, 장착 및 설정작업 시 손가락이 끼이거나 눌려서 입을 수 있는 상해 위험