Replace front crankshaft radial sealing ring

AR03.20-P-3000RT

Replace front crankshaft radial sealing ring

14.4.05

 

Remove/install

Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

 Danger!

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

When moving components, ensure that no body parts or limbs are within the operating range of moving parts.

AS00.00-Z-0011-01A

1

Open engine hood

AR88.40-P-1000RT

2

Remove the partition wall between the wheelhouse liners

AR62.30-P-2400RT

3

Remove air filter housing

AR09.10-P-1150RT

4

Remove fan shroud

AR20.40-P-5000RT

5

Attach guard plate for radiator / condenser



Guard plate for radiator / condenser

WF58.50-P-0110-01A

6

Remove poly V-belt (2)

AR13.22-P-1202RT

7

Remove belt pulley/vibration damper (3)

AR03.30-P-1600RT

8

Remove the crankshaft radial seal (4)

 Do not damage crankshaft and mounting hole for crankshaft radial seal. Use a clean cloth as a base.

 Use a screwdriver to press out crankshaft radial sealing ring (4)

 Installation: install crankshaft radial sealing ring (4) with sleeve.

AR03.20-P-3000-01B

Sleeve

*119589011400

9

Install in the reverse order

10

Check engine oil level and correct if required.

 Vehicle must be horizontal and standing on its wheels. Measuring errors can occur if this requirement is not observed.

AR18.00-P-3035-01GZ

 Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near engine

Secure vehicle to prevent it from moving.
Wear closed and snug-fitting work clothes.
Do not grasp hot or rotating parts.

AS00.00-Z-0005-01A

11

Conduct engine test run and check the engine for oil leaks

 In the event of oil loss determine and eliminate cause, otherwise malfunctions, transmission damage, and serious environmental pollution may occur.

 Determine oil leakage after spraying the cleaned and dried surrounding area with MB contrast spray.

MB contrast spray

*BR00.45-Z-1001-03A

12

Read out fault memory and erase if required

 Stored faults which may be caused by disconnecting cables or by simulation during test operations, must be erased in the fault memory after completing the work.



Connect STAR DIAGNOSIS and read out fault memory

AD00.00-P-2000-04A

STAR DIAGNOSIS diagnosis system

*WH58.30-Z-1048-13A

Number

Designation

WH58.30-Z-1048-13A

STAR DIAGNOSIS diagnosis system, Compact Passenger Car

6511 1801 00

Number

Designation

Order number

BR00.45-Z-1001-03A

Crack detector

A 000 989 03 59