Service information: Notes on connecting additional electrical consumers, assignment of connecting points

D54.25-1108-11

Picture 1

1 J201

Circuit: 56 unfused

Installation location: Behind glove compartment

Line color: ws/sw

2 J202

Circuit: 58 unfused

Installation location: Behind glove compartment

Line color: gr/gn

3 J3

Circuit: 31

Installation location: Behind glove compartment

Line color: br

D54.25-1109-11

Picture 2

4 J16

Circuit: 15 unfused

Installation location: Behind electrical center

Line color: sw

5 J18

Circuit: 30 unfused

Installation location: Behind electrical center

Line color: rt

D54.25-1110-11

Picture 3

6 J23

Circuit: Circuit 54 brake light

Installation location: Behind glove compartment

Line color: sw/rt ws

D54.25-1111-11

Picture 4

7 J28

Circuit: D+

Installation location: Behind glove compartment

Line color: bl/ws

D54.25-1112-11

Picture 5

8 J30

Circuit: C3 signal

Installation location: Behind glove compartment

Line color: gn/rt

D54.25-1113-01

Picture 6

9 J30.1

Circuit: C3 signal

Installation location: Behind instrument cluster

Line color: gn/rt

Recently, an increased number of defective electrical centers which have been irreparably damaged as a result of overloading caused by incorrect electrical connections have been sent in to the warranty claims department.

This overloading is caused by connecting electrical accessories to the wrong connecting points or as a result of double assignment of the connecting points.

Charred safety clamps, charred electrical connections and contactless connectors are indications of this fault.

Inspections of the defective electrical centers reveal irreparably damaged processors and electric circuits.

-----------------------------------------------------------------------------------------

 We would like to point out that damage caused by incorrectly installed detachable parts or modified parts are not covered by the warranty.

Additional consumers should only be connected to the specified pick-off points described in the diagnosis manual.

Existing fuses and internal vehicle circuits fitted at the factory should not be tapped or used as additional signal sources.

The existing pick-off points specified in the table are used for connecting electrical accessories.

All electrical accessories connected at a later time must be protected by means of dedicated fuses (by fuse blocks if necessary).

-----------------------------------------------------------------------------------------

Specified pick-off points