Remove/install front door window

AR72.10-S-1910S

Remove/install front door window

06.12.2019

Model

636, 639

Shown up to vehicle identification number (VIN) 225037

1

Cover

3

Sealing rail

5

Rubber mounts

2

Window guide rubber

4

Clamping jaws

 Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

 Danger

Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)

Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.

AS00.00-Z-0035-01A

 Caution

Risk of injury from contusions to hands if window glass is not secured

Secure window to prevent it from falling down.

AS67.00-Z-0002-01A

Topical note

General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system

AH00.00-Z-0300-01A



Remove

1

Move window in front door to bottom end position

2

Remove door foil from front door

AR72.10-S-1010S

3

Remove trim (1)

 Long wedge

*115589035900

4

Remove window guide rubber (2) and inner and outer sealing rail (3)

AR72.10-S-1905S

5

Move window lift in front to position

AR72.10-S-1800-04S

 Then disconnect all electrical connectors.

6

Loosen nuts and bolts on clamping jaws (4)

7

Remove window



Install

8

Install window

 When replacing window, install rubber mounts (5) in window guide rail.

9

Tighten nuts and screws on clamping jaws (4) several turns

 It should still just be possible to move the window for adjustment.

10

Move power window in front door to lower end position

AR72.10-S-1800-04S

11

Remove window guide rubber (2) and inner and outer sealing rail (3)

AR72.10-S-1905S

 Ensure that window guide rubber (2) and sealing rails (3) are seated correctly.

12

Adjust window

AR72.10-S-1800-04S


For this purpose move window up until nuts and bolts on clamping jaws (4) are accessible in upper position, then move window toward rear to stop, ensuring that window is adjusted parallel in window guide rail (arrow).
Malfunctions and noises can arise otherwise.

13

Tighten nuts and bolts on clamping jaws (4)

 Model 636, 639.### ## as of 252530
Model 639.### ## up to 252529Bolt/nut for attachment of side window to window lifter

*BA72.10-N-1010-01A



Check

14

Check window for proper function

 Check whether window opens and closes correctly, readjust window if necessary.



Install

15

Install cover (1)

16

Install door foil on front door

AR72.10-S-1010S

 Front door

Number

Designation

Model 639.### ## up to 252529

Model 636, 639.### ## as of 252530

BA72.10-N-1010-01A

Bolt/nut for attachment of side window to window lifter

Nm

9

9