Remove/install door sill molding on sliding door

AR68.30-S-1312S

Remove/install door sill molding on sliding door

06.12.2019

Model

636, 639

Shown on model 639.6 on the right side of the vehicle

1

Door sill

2

Door frame rubber seal

 

Remove/install

 Danger

Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)

Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.

AS00.00-Z-0035-01A

Topical note

General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system

AH00.00-Z-0300-01A

1

Remove the rear trim on the bench seat cross strut

Only with model 639.6/70 with code S23 (front passenger bench seat) or with code SH4 (front passenger double bench seat, comfort)

AR68.30-S-1404S

2

Remove paneling from B-pillar

Only with model 636, model 639 except code D50 (full-width partition wall), except code D53 (full-width partition wall with 1 sliding window)

AR68.30-S-4700S

 Installation: Check clips, replace if necessary.

 Long wedge

*115589035900

3

Remove the door sill (1) using the long wedge

 Installation: Check the fixing clips; replace if necessary. Check the door frame rubber seal (2) to ensure that it is seated correctly.

 Long wedge

*115589035900

4

Install in the reverse order