Remove/install roof lining in rear passenger compartment

AR68.30-D-7619TSR

Remove/install roof lining in rear passenger compartment

12.02.2019

Model

907.2

Shown on model 907.2## 1#

1

Roof lining in the rear passenger compartment

3

Front passenger side B-pillar trim

1.1

Front roof lining

4

Frame seal

2

Driver's side B-pillar trim

5

Frame seal

1

Roof lining in the rear passenger compartment

1.1

Front roof lining

6

Expansion rivet

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

 

Remove/install

1

Remove rear interior lamp.

AR82.20-D-0124TSR

2

Release driver's side B-pillar trim (2) in the top area.

AR68.30-D-4707TS

3

Release front passenger side B-pillar trim (3) in the top area.

AR68.30-D-4706TS

4

Release frame seals (4, 5) in the area of the roof lining in the rear passenger compartment (1).

5

Remove both C-pillar trims.

Model 907.2
with code V07 (Rear wall panelling)

AR68.30-D-4490TSA

6

Remove top rear panel trim.

Model 907.2
with code V07 (Rear wall panelling)

AR68.30-D-4751TSR

7

Tilt rear bench seat back into the original position.

Model 907.2
with code V07 (Rear wall panelling)
except code S92 (Deletion seats passenger comp. if double cab)

 Do not tighten down rear bench seat.

8

Unclip roof lining in the rear passenger compartment (1) from the retaining clips (arrows A).

9

Unclip front roof lining (1.1) from the retaining clips (arrows B).

10

Pull front roof lining (1.1) toward the bottom until the expansion rivets (6) are accessible.

11

Remove expansion rivets (6) and remove roof lining in the rear passenger compartment (1).

 Installation: Ensure electrical wiring harness for the rear interior lamp is guided through the cutout in the roof lining in the rear passenger compartment (1).

 Clip remover

*452589016300

12

Check retaining clips of the roof lining in the rear passenger compartment (1) and front roof lining (1.1) for damage .

If damage is detected,



replace corresponding retaining clip.

13

Install in the reverse order