Remove/install underbody trim on high-voltage battery carrier

AR61.30-D-1002TE

Remove/install underbody trim on high-voltage battery carrier

03.12.2019

Model

910 with engine 780.703

Shown with code E4T (high-voltage battery (47 kWh))

1

Underfloor paneling, right

2

Underfloor paneling, left

3

Rear section of undercarriage paneling

 Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

 Danger

Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)

Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.

AS00.00-Z-0035-01A

Topical note

General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system

AH00.00-Z-0300-01A

 

Remove/install

1

Raise vehicle.

AR00.60-D-1000-04TS

Topical note

Special instructions for lifting and supporting vehicle

AH00.60-N-0100-01TS

2

Remove front right underfloor paneling in the area of the overlap to the right underfloor paneling (1).

AR61.30-D-1001-01TS

 Do not remove front right underfloor paneling.

3

Remove right underfloor paneling (1).

AR61.30-D-1002-01TE

4

Remove front left underfloor paneling in the area of the overlap to the left underfloor paneling (2).

AR61.30-D-1001-02TS

 Do not remove front left underfloor paneling.

5

Remove left underfloor paneling (2).

AR61.30-D-1002-02TE

6

Remove rear underfloor paneling (3).

Model 910 with engine 780.703
with code E4T (High-voltage battery (47 kWh))

AR61.30-D-1002-03TE

7

Install in the reverse order.