ar6130d100203te

Remove/install underbody trim at rear on high-voltage battery carrier

Type ar · topic 61.30 · version 0101 · 2019-12-09

Applies to: Model 910 with engine 780.703 with code E4T (High-voltage battery (47 kWh))

Where it sits

Function group 3 Body › 61 Substructure › 61.30 Splash guard — Series 910

EinPAS 35 Body/frame/detachable parts › 35.25 Insulation/trim below/sealing/underbody protection › 35.25.41 Underfloor paneling/noise encapsulation/underbody protection — Series 910

Also applies to engines/gearboxes: 780 703

AR61.30-D-1002-03TE

Remove/install underbody trim at rear on high-voltage battery carrier

Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

Danger

Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)

Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.

AS00.00-Z-0035-01A

Topical note

General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system

AH00.00-Z-0300-01A

Model

910 with engine 780.703

with code E4T (High-voltage battery (47 kWh))

Remove/install underbody trim at rear on high-voltage battery carrier

1

Remove underfloor paneling (1).


To do so, remove the expansion rivets (2).


Installation: Check expansion rivet (2) for damage.


In the case of a corresponding finding,

Replace damaged expansion rivet (2).



2

Install in the reverse order.


D61.30-A005-75

Referenced documents