ar4610d020001a

Set the clock spring contact to center position

Type ar · topic 46.10 · version 0100 · 2007-07-11

Applies to: MODEL 690.6, 901, 902, 903, 904, 905.6 with CODE (SA5) Driver airbag MODEL WD1, WD2, WD3, WD6, WD7, XD1, XD2, XD3, XD6, XD7, YD1, YD2, YD3, YD4, YD5, YD6, YD7 MODEL 901.6, 902.6, 903.6 except CODE (SA5) Driver airbag with CODE (BB3) Electronic Stability Program

Where it sits

Function group 2 Chassis › 46 Steering › 46.10 Steering wheel, jacket tube, steering shaft, steering lock — Series 690 (models 6**) · Series 901 · Series 902 · Series 903 · Series 904 · Series 905 (models 6**)

EinPAS 25 On-board/network/multifunction › 25.15 Network/multifunction › 25.15.18 Switch/switch group/control panel — Series 690 (models 6**) · Series 901 · Series 902 · Series 903 · Series 904 · Series 905 (models 6**)

AR46.10-D-0200-01A

Set the clock spring contact to center position

Set the clock spring contact to center position

D46.10-1139-11

The center position of the clock spring contact (R5) is crucial for trouble-free function of the airbag and the signaling system. When removed this is guaranteed by the mounting screws (1).

If the clock spring contact (R5) has nevertheless been twisted, e.g

if steering coupling is removed,

if securing screws turned out fully,

the center position is to be determined as follows:

1 Remove clock spring contact (R5).

2 Screw mounting bolts (1) fully into the clock spring contact (R5).

3 Turn the clock spring contact (R5) as far to the left until a slight resistance is detectable.

The clock spring contact (R5) is rolled up completely.

4 Turn (turn back) clock spring contact (R5) 3 to 3.5 revolutions clockwise until the mounting bolts (1) can be unscrewed again and fix the clock spring contact (R5) in position.

The complete rotation range of the clock spring contact (R5) is 6 to 7 revolutions.