AR18.40-D-4111D | Remove/install oil level sensor | 9.2.06 |
ENGINE 904.908 ## up to 049131 in MODELS 668, 670
D18.40-0003-06
1 Oil level sensor
2 Sealing ring
3 Oil level sensor connector
4 Noise encapsulation panel
| Remove/install | ||
1 | Remove forked crossmember | ||
2 | Remove noise encapsulation panel (4) at oil pan | Installation: Quick-release fittings must latch. | |
3 | Extract or drain engine oil | ||
4 | Disconnect connector (3) and cable connector of oil level sensor (1) | ||
5 | Remove oil level sensor (1) | Installation: Install new sealing ring (2). | |
| |||
6 | Install in the reverse order | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the running engine | Secure vehicle to prevent it from moving by itself. | |
7 | Start engine and observe oil pressure gauge with the engine idling | Do not rev up engine so long as no oil pressure is indicated. The oil pressure gage must indicate oil pressure after about 10 seconds. | |
8 | Switch off engine and check for leaks | Wait about 5 minutes before inspecting engine oil level and adjust to correct level. |
Check values for engine oil pressure
Number | Designation | Engines | ||
BE18.00-N-1001-01C | Engine oil pressure at | Idling speed | bar | 0.5 |
maximum speed | bar | 2.5 | ||
Oil level, oil pressure sensor
Referenced documents
- ap1800d0101a Engine oil and oil filter change
- ar1840d411101d Separate, connect plug connection and cable strap of oil level sensor
- ar3100d1100d Remove, install forked crossmember
- as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.