Shown on engine 276.8 in model 231 |
1 | Charge air cooler |
2 | Clamp |
3 | Screw/bolts |
4 | Throttle valve actuator |
5 | Throttle valve actuator electrical connection |
P07.51-2101-06
| Notes on avoiding damage through contamination and foreign objects | ||
| Remove/install | ||
1 | Remove upper engine cover | ||
2 | Detach left charge air pipe from left ATL | ||
3 | Detach right charge air pipe from right ATL | ||
4 | Detach charge air cooler and place to one side with coolant hoses still connected | ||
5 | Unclip electrical line on throttle valve actuator (4) | ||
6 | Release and disconnect electrical connection (5) | ||
7 | Remove screw/bolt (3) | Bolt, air duct housing and throttle valve actuator to air intake pipe | |
8 | Take throttle valve actuator (4) out of the engine compartment | Installation: Replace seal. | |
9 | Install in the reverse order | ||
10 | Read out fault memory using the diagnostic system and clear if necessary | ||
| |||
Danger ! | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
11 | Carry out an engine test run, checking the engine for proper operation and leaktightness |
Referenced documents
- ad0000p200004a Connect STAR DIAGNOSIS and read out fault memory
- ad0000p200004a
- ah0000p500001a Notes on avoiding damage through contamination and foreign objects
- ar0941p1311rka Remove/install charge air pipe
- ar0941p6819rka Remove/install charge air cooler, water-cooled
- as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.