Remover/install bar-type link

AR35.15-D-0200H

Remover/install bar-type link

17.12.2015

Rear axle

741.412/415 in model 906.11/13/21/23/61/63/71/73

with code PL9 (Air suspension, company VB-Airsuspension)

Rear axle

741.421/423 in model 906.11/13/21/23/61/63/71/73

with code PL9 (Air suspension, company VB-Airsuspension)

1

Control arm

4

Castle nut

7

Screw

2

Split pin

5

Ball joint

3

Carrier plate

6

Nut

 Danger !

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A



Notes on air suspension

AH32.22-N-1000-01H



Notes on self-locking nuts and bolts

AH00.00-N-0001-01A



Remove

1

Deactivate air suspension

AR32.22-D-6000-02H

2

Raise vehicle

AR00.60-D-1000H

3

Secure rear axle using a mounting plate and major assembly mount



000 588 11 62 00 Major assembly mount

WS01.00-P-0092B



000 588 10 62 00 Support plate

WS26.00-P-3309B

 Position the mounting plate and major assembly mount at the center of the rear axle.

4

Remove bolt (7) and swivel control arm (1) downwards

 Counterhold nut (6).

5

Remove split pin (2)

6

Unscrew castle nut (4)

7

Press ball joint (5) off carrier plate (3) using puller and remove

 Before pressing off the control arm (1), secure it to prevent it from falling down.

 Puller

*221589003300



Check

8

Check elastomer bearing of control arm (1)

When reusing the control arm (1).

If the elastomer bearing is damaged or worn



Replace elastomer bearing of control arm (1)

AR35.15-D-0202H

9

Check ball joint (5)

When reusing the control arm (1).

If the ball joint (5) is damaged or worn



Replace ball joint (5)

AR35.15-D-0203H



Install

10

Adjust new control arm (1) to length of old control arm (1)

When replacing the control arm (1).

11

Mount ball joint (5) on carrier plate (3)

12

Tighten castle nut (4)

 Castle nut, bar link ball joint to lower carrier plate

*BA32.22-N-1009-03H

13

Install new cotter pin (2)

14

Position control arm (1) and screw in screw/bolt (7) a few turns

15

Remove support plate and major assembly mount

16

Lower vehicle

17

Tighten bolt (7)

 Counterhold nut (6).

 Bar link to body crossmember

*BA32.22-N-1007-03H

18

Activate air suspension

AR32.22-D-6000-02H

19

Adjust control arm (1)

AR35.15-D-0201H

 Air suspension

Number

Designation

Model 906 with code PL9 (Air suspension from VB Air suspension)

BA32.22-N-1007-03H

Bar link to body crossmember

Nm

200

 Air suspension

Number

Designation

Model 906 with code PL9 (Air suspension from VB Air suspension)

BA32.22-N-1009-03H

Castle nut, bar link ball joint to lower carrier plate

Nm

75