N27.60-2076-06
Shown without CODE (ZG2) Permanent all-wheel drive
1 Transmission housing
2 Selector lever
3 Sealing ring
4 Detent plate
5 Screw
6 Park detent
7 Spring
8 Pilot bushing
9 Retaining ring
10 Bearing bolt
11 Retaining ring
| Remove/install | ||
Danger! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | |
1 | Remove engine crossmember at rear | Only on model 636, Model 639 without code (ZG2) Permanent all-wheel drive | |
2 | Remove rear engine support | Only on model 636, Model 639 without code (ZG2) Permanent all-wheel drive | |
3 | Remove transfer case | Only on model 639 with code (ZG2) Permanent all-wheel drive | |
4 | Remove automatic transmission oil pan | ||
5 | Remove electrohydraulic controller unit | ||
6 | Remove bolt (5) at detent plate (4) | | |
7 | Remove selector lever (2) | Installation: Check sealing ring (3) and replace if necessary. | |
8 | Remove detent plate (4) with tapered rod | ||
9 | Remove circlip (11) on bearing pin (10) | ||
10 | Remove bearing pin (10) | Press bearing pin (10) out of transmission housing (1) using a suitable tool. | |
11 | Remove circlip (9) on pilot bushing (8) | Standard tools gotis://G_58.3_06.1 | |
12 | Remove guide bush (8) | Press park detent (6) as far as possible against the spring (7) and pull out pilot bushing (8) using a bar magnet. | |
13 | Remove park detent (6) together with spring (7). | Installation: Press spring (7) onto stud of park detent (6) and install both components in transmission housing (1). | |
14 | Install in the reverse order |
Housing
Henviste dokumenter
- ar2210s1170s
- ar2210s4360s
- ar2710s7030s
- ar2719s0200s
- ar2810s0100s
- as0000z001001a Livsfare, hvis køretøjet glider ned fra eller tipper på liften.