P27.00-A005-09
Shown on model 177 with engine 654 |
1 | Cap | 2 | Filler neck |
Shown on transmission 724.1 from below |
8 | Sensor |
9 | Guide tube for ultrasound measurement |
P27.00-A010-11
Danger | Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC) | Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines. | |
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Caution | Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. | |
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
Topical note | General information on vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system as well as personal protective equipment | ||
Notes on automatic transmission | |||
Preparatory tasks | |||
1 | Put transmission into neutral position. | ||
2 | Secure vehicle to prevent it moving away. | ||
3 | Connect diagnostic device. | ||
| |||
4 | Check transmission oil temperature using diagnostic device. | The transmission oil temperature must be between 40 °C and 84 °C. | |
If transmission oil temperature is less than 40 °C: | |||
| |||
Start engine and let transmission warm up. | |||
5 | Start "Vehicle commissioning" routine using diagnostic device. | Select menu item "Diagnosis" | |
When the functions are active, "P" and "N" flash alternately in the instrument cluster. | |||
6 | Start "Adjust transmission oil level" routine using diagnostic device. | ||
7 | Lift vehicle with vehicle lift. | ||
8 | Remove rear bottom engine compartment lining. |
| |
Transmission 724.1 in model 118, 177, 247 with engine 654 | |||
9 | Clean contact surface on oil pan of transmission. | Assembly cleaner | |
10 | Coat sensor surface of measuring head (8) with couplant. | ||
| 000 588 09 19 00 Oil level sensor | ||
MB Plastilube brake paste (brownish) | |||
11 | Attach measuring head (8) of oil level sensor at guide tube for ultrasound measurement (9) and wait until value stabilizes. | ||
| 000 588 09 19 00 Oil level sensor | ||
| Check | ||
12 | Compare read-off oil level with specified oil level. | If read-off oil level matches specified oil level: | |
| |||
Continue with operation step 21. | |||
Remove | |||
13 | Lower vehicle with vehicle lift. | ||
14 | Remove air filter housing. |
| |
Transmission 724.1 in model 118, 177, 247 with engine 282 | |||
Transmission 724.1 in model 118, 177, 247 with engine 654 | |||
Transmission 724.1 in model 118, 177, 247 with engine 139 | |||
15 | Remove cap (1) from filler neck (2). | ||
Adjust to correct level | |||
16 | Add automatic transmission fluid until specified oil level is reached. | ||
| Automatic transmission fluids (ATF) (specification 236.22) | ||
Funnel | |||
| Install | ||
17 | Fit cap (1) onto filler neck (2) and latch into place. | ||
18 | Clean transmission from above. | Assembly cleaner | |
19 | Install air filter housing. |
| |
Transmission 724.1 in model 118, 177, 247 with engine 282 | |||
Transmission 724.1 in model 118, 177, 247 with engine 654 | |||
Transmission 724.1 in model 118, 177, 247 with engine 139 | |||
20 | Lift vehicle with vehicle lift. | ||
Concluding tasks | |||
21 | Remove measuring head (8) of oil level sensor from guide tube for ultrasound measurement (9). | ||
| 000 588 09 19 00 Oil level sensor | ||
22 | Clean transmission from below. | Assembly cleaner | |
23 | Install rear lower engine compartment paneling. |
| |
Transmission 724.1 in model 118, 177, 247 with engine 654 | |||
24 | End "Adjust transmission oil level" routine using diagnostic device and disconnect diagnostic device. | ||
|
126 589 12 63 00
Funnel
Henviste dokumenter
- ad0000p200006mfa
- ah0000p500001a Oplysninger om forebyggelse af skader på grund af snavs og fremmedlegemer
- ah0000z030001a Generelle oplysninger ved køretøjer med højvoltsnet og/eller litium-ion-batteri og/eller gasdrivsystem samt personligt beskyttelsesudstyr
- ah2719p000101nkb Oplysninger om automatgearkasse
- ah2719p000101nkb
- ar0060p1006a
- ar0910p1150mfc
- ar0910p1150mfd
- ar0910p1150mff
- ar0910p1150mfg
- ar6120p1105mfa
- ar6120p1105mfe
- as0000z000201a Fare for personskade på hud og øjne ved håndtering af varme eller glødende genstande
- as0000z000501a Fare for ulykke ved automatisk igangsætning når motoren kører. Fare for personskade på grund af knusning og forbrænding, hvis der arbejdes mens motoren startes eller kører
- as0000z001701a Fare for personskade på grund af snitsår eller hudafskrabninger grundet skarpkantede køretøjsdele
- as0000z003501a Livsfare ved arbejde på komponenter og systemer med U >= 30 V vekselspænding (AC) eller U >= 60 V jævnspænding (DC)
- as0040z000101a Fare for personskade på hud og øjne ved håndtering af gearolie. Sundhedsfare ved indtagelse af gearolie
- bb0040p023622a
- ws2700p0188b