ar2010s2460se

Remove/install coolant thermostat

Type ar · emne 20.10 · version 0300 · 2010-07-12

Gælder for: ENGINES 642 in MODEL 639

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 1 Motor › 20 Motorkøling › 20.10 Kølevæskepumpe, kølevæsketermostat — Serie 639

EinPAS 15 Motor › 15.25 Motorkølesystem › 15.25.30 pumpe/termostat/forvarmningsapparat — Serie 639

Gælder også for motorer/gearkasser: 642 ***

AR20.10-S-2460SE

Remove/install coolant thermostat

6.7.10

ENGINES 642 in MODEL 639

Remove/install coolant thermostat

S20.10-4510-07

Shown on engine 642.990

3 Bolts

4 Screw

5 Bolts

1 Coolant thermostat housing

2 Coolant pipe

Remove/install coolant thermostat

S20.10-4516-04

Shown on engine 642.890

1 Coolant thermostat housing

5 Bolts

6 Coolant hose

R48/3 Thermostat heating element

Modification notes

13.1.10

Methods and cross-reference altered

Operation step 3

10.5.10

Method supplemented and reference added

Steps 4.2, 5

Remove/install

Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.

AS00.00-Z-0010-01A

Danger!

Risk of injury to skin and eyes caused by scalding from contact with hot coolant spray. Risk of poisoning caused by swallowing coolant.

Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers.

Wear protective gloves, protective clothing and safety glasses.

AS20.00-Z-0001-01A

Notes on coolant

AH20.00-N-2080-01A

1

Remove engine trim panel

Only applies to front engine cover.

AR01.10-S-2405SE

2

Drain coolant

AR20.00-S-1140S

3

Remove fuel hose on coolant thermostat housing (1)

4.1

Remove coolant pipe (2) on coolant thermostat housing (1)

Engine 642.990

For this purpose, remove bolts (3, 4). Do not remove hose from coolant pipe (2).

Installation: Replace sealing ring.

*BA20.10-N-1005-01Q

4.2

Remove coolant pipe (6) on coolant thermostat housing (1)

Engine 642.890

For this purpose detach coupling from coolant hose (2).

Open and close coupling.

AR09.41-P-1311-01AL

5

Disconnect electrical connector from thermostat heating element (R48/3)

Engine 642.890 only

6

Remove coolant thermostat housing (1)

To do this, remove bolts (5).

Installation: Replace sealing ring.

*BA20.10-N-1005-01Q

7

Install in the reverse order

Coolant pump, coolant thermostat

Number

Designation

Engine
642

BA20.10-N-1005-01Q

Bolt, coolant thermostat housing to charge air manifold

Nm

9

Henviste dokumenter