P18.30-2166-09
1 | Feed line | 4 | Screw/bolt for oil return line bracket | 7 | Screw | ||
2 | Return flow pipe | 5 | Screw | 8 | Screw | ||
3 | Screw/bolt for feed line oil line bracket | 6 | Screw | 9 | Wide open throttle bleed line |
| Remove/install | ||
1 | Detach coolant lines from turbocharger and pull to the front | ||
Do not remove coolant lines. The feed line remains on the crankcase and the return line on Y-fitting on the transmission cooling coolant circulation pump. | |||
2 | Remove upper engine cover | ||
Only perform operation steps 3 to 7 to remove feed line (1) | |||
3 | Detach heat protection cable bushing from feed line (1) | Installation: Check heat protection cable bushing for damage; replace if necessary. | |
4 | Remove screw/bolt (5) | Installation: Replace sealing ring. | |
Bolt, oil feed line to turbocharger/crankcase/bracket | |||
5 | Remove screw/bolt for oil line feed line bracket (3) | Bolt, oil feed line to turbocharger/crankcase/bracket | |
6 | Detach wide open throttle vent line (9) at cylinder head cover and bracket and place to one side | ||
| |||
7 | Remove screw/bolt (6) and feed line (1) upwards | Installation: Replace sealing ring. | |
Bolt, oil feed line to turbocharger/crankcase/bracket | |||
Only perform operation steps 8 to 12 to remove return line (2) | |||
8 | Remove heat shield at turbocharger | Bolt, heat shield to bracket | |
9 | Detach heat protection cable bushing from return line (2) | Installation: Check heat protection cable bushing for damage; replace if necessary. | |
10 | Remove screw/bolt (7) | Installation: Replace sealing ring. | |
Bolt, oil return line to turbocharger/crankcase/bracket | |||
11 | Remove oil return line bracket screw/bolt (4) | Bolt, oil return line to turbocharger/crankcase/bracket | |
12 | Remove screw/bolt (8) and return line (2) upwards | Installation: Replace seal. | |
Bolt, oil return line to turbocharger/crankcase/bracket | |||
13 | Install in the reverse order | ||
| Check | ||
14 | Check oil level of the engine and correct if necessary | ||
| |||
Danger ! | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
15 | Carry out an engine test run and check engine for leaktightness |
Henviste dokumenter
- ap1800p0101ahh Motorolie- og oliefilterskift
- ar0120p0002mta
- ar2020p7440mta
- as0000z000501a Fare for ulykke ved automatisk igangsætning når motoren kører. Fare for personskade på grund af knusning og forbrænding, hvis der arbejdes mens motoren startes eller kører