ad8035s3006a

Radio frequency locking (RFL) diagnosis operational check

Type ad · emne 80.35 · version 0101 · 2003-06-13

Gælder for: MODEL 638 with CODE (FZ1) Central locking system with remote control with CODE (FZ3) Convenience locking system

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 3 Karrosseri › 80 Centrallåsesystem, komfortbetjening, kørselsgodkendelsessystemer › 80.35 Radiofjernbetjening — Serie 638

AD80.35-S-3006A

Radio frequency locking (RFL) diagnosis operational check

22.8.97

MODEL 638
with CODE (FZ1) Central locking system with remote control
with CODE (FZ3) Convenience locking system

Radio frequency locking system (RFL), arrangement of components

GF80.35-S-0001-04A

Radio frequency locking system (RFL), diagnosis previous knowledge

AD80.35-S-2002A

Radio frequency locking system (RFL) diagnosis notes

AD80.35-S-2002-10A

a

Check operation of central locking system/convenience locking system and ATA (if present)

b

Check RFL transmitter key batteries

c

Battery voltage 11-14 V

d

Fuses F73 and F74 O.K.

e

Central locking system/convenience locking system and ATA (if present) O.K.

f

Transmitter key batteries O.K.

g

Transmit signal synchronized

h

Key removed from ignition

i

Doors and tailgate closed

j

Central locking system/convenience locking system unlocked

k

HHT disconnected

Operational monitoring

Scope of test

Operation / requirement

Specified value

Possible cause / remedy

Lock vehicle using radio frequency locking system

Close hinged key on transmitter

Vehicle completely locked

AD80.35-S-6002-01A

AD80.35-S-6002-02A

AD80.35-S-6002-04A

Unlock vehicle using radio frequency locking system

Open hinged key on transmitter

Vehicle completely unlocked

AD80.35-S-6002-01A

AD80.35-S-6002-02A

AD80.35-S-6002-04A

Activate immobilizer

At least one door open.

Close hinged key on transmitter.

Central locking system locked and unlocked ("door open" message).

Open hinged key out of range.

Ignition ON, wait 5 sec. and operate starter.

Immobilizer monitoring lamp permanently on, engine won't start

AD80.35-S-6002-01A

AD80.35-S-6002-02A

AD80.35-S-6002-03A

AD80.35-S-6002-05A

AD80.35-S-6002-06A

Engine control module fault memory and actual values

Deactivate immobilizer

Close hinged key on transmitter and open it again. Ignition ON and operate starter.

Immobilizer monitoring lamp extinguishes after 2 sec. (engine 111) or depending on pre-glow time (engine 601), engine starts.

AD80.35-S-6002-01A

AD80.35-S-6002-02A

AD80.35-S-6002-03A

AD80.35-S-6002-05A

AD80.35-S-6002-06A

Engine control module fault memory and actual values

Henviste dokumenter