ad0761p400033a

Fault code description - ME-SFI - gear comparison (multiple times) negative

Type ad · emne 07.61 · version 0104 · 2003-06-10

Gælder for: ENGINES 112.910, 112.911 up to 31.5.00, 112.920, 112.921 up to 31.5.00, 112.923, 112.940 /941 /942 up to 31.5.00, 112.943 ENGINES 113.940 /942 /943 up to 31.5.00, 113.961 ENGINES 112.945, 113.962 up to 30.11.00 in MODEL 463

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 1 Motor › 07 Blandingstilberedning › 07.61 Benzinindsprøjtnings- og tændingssystem ME — Serie 463

EinPAS 15 Motor › 15.45 Motorstyring › 15.45.1 Grundinformation — Serie 463

Gælder også for motorer/gearkasser: 112 910, 112 911, 112 920, 112 921, 112 923, 112 940, 112 941, 112 942, 112 943, 112 945, 113 940, 113 942, 113 943, 113 961, 113 962

AD07.61-P-4000-33A

Fault code description - ME-SFI - gear comparison (multiple times) negative

1

Fault code

2

Fault storage

Activation of malfunction indicator lamp for engine diagnosis (EURO3/4)

or CHECK ENGINE (MIL)

after the end of the test period and faults

after two successive driving cycles with faults

3

Frequency of the test

continuous

4

Fault setting conditions

Comparison of detected gear and engaged gear (calculated gear ratio) negative at least 6x

5

Test prerequisites

- 2nd, 3rd, 4th or 5th gear detected

- engine speed > 450 rpm

- output shaft rotational speed > 180 rpm

- no shift operation

6

The gear ratios are calculated from the following variables: speed signal n2, speed signal n3 and output shaft rotational speed (determined via rear wheel speed).

Faults are detected by the ETC control module and sent via the CAN data bus to the ME-SFI control module. The faults are stored and the malfunction indicator lamp is activated by the ME-SFI control module. Also read out ETC diagnostic trouble code memory, fault code 55.