Removing and installing torque converter of torque converter clutch

AR25.40-G-0400A

Removing and installing torque converter of torque converter clutch

12.3.96

 

Removal, installation

1

Remove torque converter clutch (8)

AR25.40-G-0100A

2

Remove torque converter (1)

 The torque converter (1) should only be pulled off in the upright position

 Installation: The slots of the torque converter shaft (5) must engage fully in the journals (9) of the pressure oil pump.
 Installation: The torque converter shaft (5) must be connected positively with the splines on the stator shaft (7) and turbine shaft (6).

3

Check torque converter (1) for leaks and condition

 If the torque converter is defective 

Unscrew screw plug (4), drain and dispose of oil, replace defective torque converter (1).

4

Install in reverse order

 Prior to installing the torque converter clutch, 

check installed dimension of the torque converter

AR25.40-G-0400-01A

*BE25.40-N-1001-03A



*WE58.40-Z-1002-19A

5

Fill torque converter clutch with oil

AP25.40-G-0100A

6

Check for leaks

 Visual inspection.

Number

Designation

Engine 602.941 with TCC 270 in model 408

BE25.40-N-1001-03A

Installed dimension

"X"

mm

89

For figure, refer to

AR25.40-G-0400-01A

WE58.40-Z-1002-19A

Depth gage