SM15.18-W-0004B | Replacing wiring harness for cab connector to engine and transmission | 16.2.12 |
ENGINE 904 in MODELS 970.###, 972.###, 975.###, 976.### 1# as of 237128 up to 493760 with TRANSMISSION 715.050
ENGINE 906 in MODELS 970.###, 972.###, 974.###, 975.###, 976.### 1# as of 237128 up to 493760 with TRANSMISSION 715.060
Modification notes
13.1.03 | Information and reference addresses entered | Stage 14 | |
Additional WU entered | In the table Work No. of the operation texts or the standard texts and flat rates | ||
Enter modified replacement part number for wiring harness | In table parts ordering notes |
W15.18-1018-06
1 Front flap
2 Decorative grille
3 Air scoop
4 Cab-chassis connector plate cover
5 Terminal 30
6 Cab-chassis connector plate
A3 FR/FMR control module
X2.1 Cab-chassis plug connection
X2.2 Cab-chassis plug connection
X4.18 18-pin plug
Operation no. of operation texts or standard texts and flat rates
Category | Op. no. | Operation text | Time | Acc. no. | Code |
N | 024340 | WORK: REPLACING WIRING HARNESS CAB CONNECTOR TO ENGINE AND TRANSMISSION | 037 WU/3.1 h | 15 900 61 | MO-CABLE |
N | 024485 | ADDITIONAL WORK: RETROFITTING ELECTRIC LEAD TO WIRING HARNESS; VEHICLES WITH CODE N83, M16, MK3 OR MT6 | 002 WU/0.2 h | --- | --- |
N | 024494 | ADDITIONAL WORK: INSTALLING CABLE BRIDGE FOR TANDEM GENERATOR; VEHICLES WITH CODE ML2 | 002 WU/0.2 h | --- | --- |
| Remove/Install | ||
1 | Secure vehicle against rolling | ||
2 | Switch off ignition | ||
Danger! | Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices | No fire, sparks, open flames or smoking. Wear acid-resistant gloves and clothing and safety glasses with side guards. Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground. Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers. | |
3 | Disconnect ground lead from battery | ||
| Notes on battery | ||
4 | Open front flap (1) | ||
5 | Remove ornamental grill (2) | ||
6 | Remove air shroud (3). | ||
7 | Remove cover for cab/chassis connector plate (4) | Installation: The cover on the cab/chassis plug plate should be closed tightly | |
8 | Remove connector X4.18 from FR/FMR control module (A3) | ||
9 | Disconnect wire (red) for terminal 30 (5) and detach connectors (X2.1, X2.2) from cab chassis plug plate (6) | Installation: The connector (X2.2) must be tied to the engine wiring harness in vehicles without air conditioning system. | |
10 | Unclip engine wiring harness and lay down | ||
Danger! | Risk of injury from hand being jammed and bruised when tilting cab | Ensure that no one is within the tilting range of the cab during tilting. Always tilt cab to end position and secure with safety prop. | |
11 | Tilt cab | ||
| Notes on tilting cab | ||
12 | Remove sound-proofing capsule from engine on right and rear. | ||
13 | Remove sound-proofing capsule from transmission at bottom | ||
14 | Replace wiring harness from frame cross member to engine and transmission | ||
On vehicles with code N83, M16, MK3 or MT6 retrofit two electric leads on new wiring harness: | |||
Retrofit electric leads on wiring harness. | |||
15 | Install in the reverse order | ||
16 | Carry out function check |
Parts ordering notes
Part no. | Designation | Quantity |
A004 997 98 90 05 | Repair wiring harness for cable strap repair kit (45 each) only when ordering vehicle-specific original wiring harnesses or as additional order for wiring harnesses ordered before 02 December 02. | 1 |
A000 540 09 35 05 | Repair wiring harness (including 45 cable straps) for engine OM 904 with transmission G 60 left-hand steering (not for vehicles with code GB8, GB9, ML2 or N55) | 1 |
A000 540 10 35 05 | Repair wiring harness (including 45 cable straps) for engine OM 906 with transmission G 85 left-hand steering (not for vehicles with code GB8, GB9, ML2 or N55) | 1 |
A000 540 13 35 05 | Repair wiring harness (including 45 cable straps) for engine OM 904 with transmission G 60 left-hand steering with code E06, EK3, EK4, EK5 (ADR/GGVS) (not for vehicles with code GB8, GB9, ML2 or N55) | 1 |
A000 540 15 35 05 | Repair wiring harness (including 45 cable straps) for engine OM 906 with transmission G 85 left-hand steering with code E06, EK3, EK4, EK5 (ADR/GGVS) (not for vehicles with code GB8, GB9, ML2 or N55) | 1 |
For parts ordering: For vehicles with code GB8, GB9 (Allison transmission), ML2 (tandem generator) and N55 (transmission oil cooling) it is necessary to order the vehicle-specific original wiring harness via FDOK with QXVK43 and index 05. In addition to the vehicle-specific original wiring harness it is necessary to order the repair kit wiring harness On vehicles with code ML2 (tandem generator) it is necessary to order the tandem generator in addition to the vehicle-specific original wiring harness. |