Operation no. of the operation texts or standard texts and flat rates | |||||
Category | Op. no. | Operation text | Time | Acc. no. | Code |
N | 022944 | Convert vehicle to dual compressor from Knorr-Bremse company | 3,1 h | 13 905 59 | LUP-UMBAU |
N | 022949 | Extra work for converting vehicle to dual compressor on vehicle with additional power steering pump on compressor | 1,0 h | 13 905 59 | LUP-UMBAU |
N | 135926 | Extra work for: Remove/install air compressor on vehicles with air-sprung front axle | 0,7 h | - | - |
W13.30-A001-79
1 | Coolant line | 4 | Control connection | 6 | Coolant line | ||
2 | Coolant line | 4.1 | Control line | A | Dual compressor (Voith) | ||
3 | Oil pressure line (steering gear oil) (only on vehicle with additional steering axle) | 5 | Coolant line | B | Dual compressor (Knorr-Bremse) |
Topical note | Notes on the repair and extension of plastic lines of the brake and air suspension system | ||
Notes on compressed air connection systems | |||
Notes on safety-relevant components | |||
| Remove | ||
1 | Remove dual compressor (A). | ||
| Engine 471.9 | ||
| ENGINE 470.9 | ||
Remove both coolant lines (1, 2), as they will be replaced during refitting and no longer used. | |||
| Install | ||
2 | Replace oil pressure line (3) of steered leading or trailing axle. | Only on vehicles with additional steering axle | |
The oil pressure line (3) must be replaced because the previous one would be too short due to the different dimensions of the new dual compressor (B). | |||
3 | Install dual compressor (B). | ||
| Engine 471.9 | ||
| ENGINE 470.9 | ||
Use new coolant lines (5, 6). | |||
4 | Retrofit control line (4.1) for dual compressor (B). | Only vehicles with engine 470.9 and vehicles with engine 471.9 without code M5B (2nd generation engine OM471) | |
Pliers | |||
Knife | |||
Clamping pliers | |||
Parameterization | |||
5 | Connect diagnostic system, start XENTRY and switch on ignition. | ||
6 | Perform initial quick test. | The initial quick test is stored until the end of the diagnosis session. | |
7 | Change parameter in Electronic Air-Processing Unit (EAPU). | To do so, select the following menu items in the "Adaptations" tab: Parameterization | |
8 | Perform final quick test. | No fault codes should be present. | |
If fault codes are still present, | |||
| |||
then process the fault codes. | |||
After obtaining special order. | |||
9 | Carry out function check with engine test run. | ||
10 | Check compressed-air connections for leak tightness. | Use commercially available leak detector spray. | |
11 | End XENTRY and remove the diagnostic system. | ||
Update Vehicle Documentation (VeDoc) | |||
12 | Update variant parts lists (SAA) and code. | ||
The modified variant parts lists (SAA) must be documented in VeDoc for correct replacement part documentation. |
000 589 12 28 00
Knife
352 589 02 37 00
Pliers
950 589 00 37 00
Clamping pliers
Parts ordering note |
Part no. | Designation | Quantity |
Vehicles with engine 470.9 without additional power steering pump on compressor | ||
A 000 827 91 59 | CD-ROM | 1 |
A 470 130 18 15 | 2-cylinder compressor | 1 |
A 000 987 26 27 | Plastic line (Ø 6 mm) | 1 |
A 004 997 13 89 | Elbow fitting | 1 |
N 910143 010012 | Screw | 4 |
A 000 997 53 34 | Threaded fitting | 1 |
A 004 997 78 89 | Fitting | 1 |
A 470 200 39 52 | Coolant line | 1 |
A 470 200 65 52 | Coolant line (vehicles with SAA 53705823) | 1 |
A 470 200 62 52 | Coolant line (vehicles with SAA53705848) | 1 |
A 470 200 96 52 | Coolant line (vehicles with SAA53715414) | 1 |
Vehicles with engine 470.9 with additional power steering pump on compressor | ||
A 000 827 91 59 | CD-ROM | 1 |
A 470 130 17 15 | 2-cylinder compressor | 1 |
A 000 987 26 27 | Plastic line (Ø 6 mm) | 1 |
A 004 997 13 89 | Elbow fitting | 1 |
N 910143 010012 | Screw | 4 |
A 000 997 53 34 | Threaded fitting | 1 |
A 004 997 78 89 | Fitting | 1 |
A 960 997 61 52 | Power steering oil line | 1 |
A 960 460 68 35 | Bracket | 1 |
A 001 995 80 02 | Clip | 1 |
A 006 997 50 71 | Connection | 1 |
N 000000 006239 | Nut | 1 |
A 470 200 39 52 | Coolant line | 1 |
A 470 200 96 52 | Coolant line (vehicles with SAA 53715414) | 1 |
A 470 200 65 52 | Coolant line (vehicles with SAA 53705823) | 1 |
A 470 200 92 52 | Coolant line (vehicles with SAA 53715412) | 1 |
A 470 200 62 52 | Coolant line (vehicles with SAA 53705848) | 1 |
Vehicles with engine 471.9 without additional power steering pump on compressor | ||
A 000 827 91 59 | CD-ROM | 1 |
A 471 130 37 15 | Dual compressor - Vehicles without code M5B (2nd generation engine OM471) | 1 |
A 471 130 60 15 | Dual compressor - Vehicles with code M5B (2nd generation engine OM471) | 1 |
A 000 987 26 27 | Plastic line (Ø 6 mm) | 1 |
A 004 997 13 89 | Elbow fitting | 1 |
N 910143 010012 | Screw | 4 |
A 000 997 53 34 | Threaded fitting | 1 |
A 004 997 78 89 | Fitting | 1 |
A 472 200 02 52 | Coolant line | 1 |
A 471 200 93 51 | Coolant line (vehicles with SAA 53705888) | 1 |
A 471 200 03 52 | Coolant line (vehicles with SAA 53705807) | 1 |
A 471 200 92 52 | Coolant line (vehicles with SAA 53705828) | 1 |
Vehicles with engine 471.9 with additional power steering pump on compressor | ||
A 000 827 91 59 | CD-ROM | 1 |
A 471 130 36 15 | Dual compressor - Vehicles without code M5B (2nd generation engine OM471) | 1 |
A 471 130 61 15 | Dual compressor - Vehicles with code M5B (2nd generation engine OM471) | 1 |
A 000 987 26 27 | Plastic line (Ø 6 mm) | 1 |
A 004 997 13 89 | Elbow fitting | 1 |
N 910143 010012 | Screw | 4 |
A 000 997 53 34 | Threaded fitting | 1 |
A 004 997 78 89 | Fitting | 1 |
A 960 997 61 52 | Power steering oil line | 1 |
A 960 460 68 35 | Bracket | 1 |
A 001 995 80 02 | Clip | 1 |
A 006 997 50 71 | Connection | 1 |
N 000000 006239 | Nut | 1 |
A 472 200 02 52 | Coolant line | 1 |
A 471 200 92 52 | Coolant line | 1 |