Overview
This document contains the following information:
General
Function requirement
Open/close trunk separator automatically
General
The trunk partition is located in the front area of the trunk.
The trunk separator Hall sensors are located on the outside, under the trunk separator, on the respective load compartment contact strip.
The trunk separator closed Hall sensor is located on the side at the rear on the left outer contact strip.
The trunk partition motor is integrated in the panel of the trunk partition.
Function requirements
Soft top not in locked end position
Trunk lid opened
Open/close trunk separator automatically
The trunk partition can be opened or closed manually by actuating the trunk partition switch. The rear control unit directly reads in the status of the trunk separator switch and actuates the trunk separator electric motor according to the open/close actuation.
To open, the trunk separator electric motor folds the panel with the trunk separator cover toward the front. The trunk separator cover releases. The shaft with the trunk separator cover moves upwards in the side guide rails. The usable trunk capacity is enabled. When closing the trunk partition electrical motor folds the panel with the roller bind trunk partition toward rear. This procedure tensions the roller blind trunk partition and the shaft the with roller blind trunk partition is pulled downward. The stowage space for the soft top is enabled. The lower end position (trunk partition closed) is sensed by the trunk partition closed Hall sensor. The trunk partition Hall sensors located at sides, recognize when the trunk partition hits obstacles during closing. The rear control unit directly reads in the signals from the trunk partition Hall sensors and evaluates them.