S72.12-4505-09
Shown on right rear door (2) |
1 | Side window(s) | 3 | Screw | 5 | Rear guide rail | ||
2 | Rear door | 4 | Bolts | 6 | Power window |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove | ||
1 | Completely open side window (1) on rear door (2) | ||
2 | Remove outer sealing rail from rear door (2) | ||
3 | Remove window guide seal from rear door (2) | ||
4 | Detach adhesive foil on inner door panel of rear door (2) in bottom area until bolts (3) are accessible | ||
5 | Unscrew bolts (4) and remove rear guide rail (5) | ||
6 | Remove bolts (3) | ||
7 | Remove side window (1) upward from window channel | ||
| Install | ||
8 | Insert side window (1) into window channel | ||
9 | Position side window (1) on power window (6) and tighten bolts (3) slightly by hand | ||
10 | Position rear guide rail (5) in rear door (2) and tighten bolts (4) slightly by hand | ||
11 | Install window guide seal on rear door (2) | ||
12 | Adjust side window (1) | ||
13 | Attach adhesive foil to inner door panel of rear door (2) | ||
14 | Install outer sealing rail on rear door (2) | ||
15 | Close side window (1) on rear door (2) |