Shown on left side window (1) |
1 | Side window(s) |
2 | Window guide seal |
S72.12-4506-05
S72.12-4507-09
Shown on left rear door |
3 | Bolts | 5 | Screw | 7 | Front guide rail | ||
4 | Nut | 6 | Bolts | 8 | Rear guide rail |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Check | ||
1 | Open side window (1) approx. 10 to 20 mm | ||
2 | Check whether top edge of side window (1) is parallel to top section of window guide seal (2) along entire length (arrows A) | ||
3 | Check whether side window (1) is in center between side sections of window guide seal (2) (arrows B) | ||
| Remove | ||
4 | Detach adhesive foil on inner door panel of rear door until bolts (3) and nuts (4, arrow C) are accessible | ||
Adjust | |||
5 | Unfasten bolts (3) and nuts (4, arrow C) | ||
6 | Move side window (1) and power window together until top edge of side window (1) is parallel to top section of window guide seal (2) along entire length (arrows A) and side window (1) is centered between side sections of window guide seal (2) (arrows B) | If adjustment range of power window is not sufficient. | |
| |||
Unfasten bolts (6) and/or bolt (5) and adjust rear window guide rail (8) and/or front guide rail (7) accordingly. Then tighten bolts (6) and/or bolt (5). | |||
7 | Tighten bolts (3) and nuts (4, arrow C) | ||
| Install | ||
8 | Attach adhesive foil to inner door panel of rear door |