Shown on right front door (2) |
1 | Side window(s) |
2 | Front door |
a | Assembly position dimension |
S72.10-4656-11
S72.10-4654-07
Shown on right front door (2) |
1 | Side window(s) | 3 | Power window | ||||
2 | Front door | 4 | Bolts |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove | ||
1 | Lower side window (1) far enough until assembly position dimension (a) is reached | Assembly position dimension (a): 100 mm. | |
2 | Loosen adhesive foil on inner door panel of front door (2) in bottom area until bolts (4) are accessible | ||
3 | Remove bolt s (4) | ||
4 | Remove side window (1) upward from window channel | ||
| Install | ||
5 | Insert side window (1) into window channel | ||
6 | Position side window (1) on power window (3) and tighten bolts (4) slightly by hand | ||
7 | Adjust side window (1) | ||
8 | Attach adhesive foil to inner door panel of front door (2) |