Shown on right front door (2) |
1 | Adhesive foil |
1.1 | Adhesive bead |
2 | Front door |
3 | Bolts |
4 | Bracket |
5 | Electrical wiring harness |
5.1 | Electrical connector |
6 | Electrical wiring harness |
6.1 | Electrical connector |
7 | Electrical wiring harness |
7.1 | Electrical connector |
8 | Electrical wiring harness |
9 | Electrical wiring harness |
10 | Cable |
S72.10-4645-06
Shown on right front door (2) on model 470 with code JS1 (360° camera) |
2 | Front door |
11 | Electrical wiring harness |
11.1 | Electrical connector |
S72.10-4675-01
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Topical note | Notes on carrying out repair work in the vehicle interior | ||
| Remove/install | ||
1 | Remove door trim at front door (2). | ||
2 | Remove screws (3) and remove bracket (4). | ||
3 | Disconnect electrical connectors (5.1, 6.1, 7.1). | ||
4 | Unclip electrical connector (11.1) from inner door panel and disconnect. | Model 470 | |
5 | Unclip connector housing of electrical connector (7.1) from inner door panel. | ||
6 | Unclip connector housing of electrical connector (11.1) from inner door panel. | ||
7 | Open cable tie at retaining clip (arrow A). | ||
8 | Unclip electrical wiring harness (8) at retaining clip (arrow B) from inner door panel. | Clip remover | |
9 | Cut adhesive bead (1.1) with a sharp knife. | | |
Installation: Press adhesive foil (1) down onto adhesive beads (1.1) with roller until there are no gaps around adhesive beads (1.1). | |||
Roller | |||
10 | Remove adhesive foil (1) from inner door panel; in this connection, guide electrical wiring harnesses (5, 6, 7, 8, 9) and cable (10) through adhesive foil (1). | | |
Model 470 | |||
11 | Check adhesive foil (1) for damage. | If there is damage, | |
| |||
Install new adhesive foil (1). | |||
12 | Check adhesive bead (1.1) for damage. | If there is damage, | |
| |||
only replace damaged section of adhesive bead (1.1). Clean adhesive surfaces and lay new adhesive bead (1.1) parallel to damaged adhesive bead (1.1). | |||
Cleaner | |||
Soft top frame sealing profile with metal core 35 m, SEALANT/butyl Bostik 1127 | |||
13 | Install in the reverse order | ||
| Check | ||
14 | Perform function test of speaker in front door (2). | ||
15 | Perform function test of side camera in outside mirror. | Model 470 |
168 589 05 63 00
Roller
452 589 01 63 00
Clip remover