Adjusting rear side windows

AR67.30-P-4200G

Adjusting rear side windows

17.4.96

Adjusting

1

Inspect aligNment of crank window at driver door, correct if necessary

AR72.10-P-1950G

2

Open vario roof

3

Remove trim (1) and cover (2) at B-pillar

4

Remove inner slot seal at B-pillar (1 screw)

5

Partially detach rear wall paneling (3) on side at B-pillar

6

Close rear side window (4), separate terminal block (M10/5 x1 and M10/6 x1) for this step and connect to power source (12 V)

7

Close crank window (5) at driver door

8

Adjust top stop for rear side window (4) (dimension" A")

 Carry out adjustment at setting screw (arrow) at top stop of rear window lifter (6)

*BE67.30-P-1001-01A

9

Inspect size of gap ("B") between edge of glass of crank window (5) and trim strip at rear side window, adjust if necessary

*BE67.30-P-1002-01A

10

To adjust, slacken front screw (arrow) at rear side window (4)

 Set gap between edge of glass of crank window (5) and rear side window (4) parallel

11

Open rear side window (4) and connect terminal block (M10/5 x1 and M10/6 x1) to wiring harness

12

Install inner shaft seal on B-pillar

13

Close vario roof

14

Screw in adjustment screw (arrow) at top of rear window lift mechanism until it makes contact with the top stop

15

Check inclination of rear side window (4) relative to top weather seal at vario roof (arrows), adjust if necessary

16

Slacken lock nut (8) and align rear side window (4) by turning the adjusting screw (9, waf 5.5) so that it rests evenly against the weather seal surround at the top (arrows) and with a slight tension

 Turning adjusting screw (9) in means moving inclination of rear side window at top further out

17

Additional adjustment facility of inclination of rear side window at top attachment point of rear window lifter (6), slacken screw (7) for this step and move rear window lifter (6) in desired direction (arrows)

 Use internal torx wrench socket T 30



*000589011000

18

Inspect contour of rear side window (4) to crank window (5) of driver door, adjust if necessary

 The crank window (5) must be positioned flush with the vertical trim strip of the rear side window (4). An adjustment is possible by setting the rear guide rail at the crank window of the driver door

19

Inspect size of gap "C" with vario roof closed

 If both side windows (4 and 5) are correctly aligned, the specified value (dimension "C") must be achieved

*BE67.30-P-1003-01A

20

Attach rear wall paneling (3)

21

Install cover (2) and trim (1)

22

Carry out operational check

Number

Designation

Model 170

BE67.30-P-1001-01A

Top projection of rear side window to crank window

Dimension" A"

mm

5

Fig. see

AR67.30-P-4200G

BE67.30-P-1002-01A

Gap between edge of glass of crank window and trim strip at rear side window

Dimension" B"

mm

5

Fig. see

AR67.30-P-4200G

BE67.30-P-1003-01A

Gap between edge of glass of crank window and trim strip at rear side window

Dimension" C"

mm

6...8

Fig. see

AR67.30-P-4200G