S60.00-4903-09
8 | Electrical connectors | 11 | Fuse holder | 14 | Cover | ||
9 | Electrical connectors | 12 | Adhesive tape | 15 | Housing | ||
10 | Relays | 13 | Cover |
S60.30-0149-09
15 | Housing | 17 | Screw | |
16 | Cover | 18 | Nuts |
Shown on model 470 with code FX9 (KEYLESS-GO) |
1 | Bracket (with code FX9 (KEYLESS-GO)) |
2 | Screw (with code FX9 (KEYLESS-GO)) |
3 | Insulation |
4 | Nuts |
S60.00-4904-06
5 | Bracket |
6 | Bolts |
7 | Hood support |
19 | Hood support bracket |
S60.00-4905-06
20 | Floor covering |
21 | Insulation |
S60.00-4906-06
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Topical note | Notes on carrying out repair work in the vehicle interior | ||
| Remove/install | ||
1 | Remove front door | ||
2 | Remove hinges of the front door | ||
3 | Remove edge guard for door cutout of front door | ||
4 | Remove hinge of hood | ||
5 | Remove windshield | ||
6 | Remove side running board |
| |
7 | Remove cross member under instrument panel | ||
8 | Remove window airbag | ||
9 | Remove roof lining through the windshield opening out of the vehicle | ||
10 | Remove paneling in footwell. | ||
11 | Remove blower housing | ||
12 | Remove atmospheric pressure sensor |
| |
13 | Remove atmospheric pressure sensor bracket | Model 470 with engine 200 | |
14 | Remove battery management control unit |
| |
15 | Remove fuse and relay module control unit in engine compartment | ||
16 | Disconnect electrical connectors (8) | ||
17 | Remove electrical connectors (9), relay (10) with bracket, and fuse holder (11) from housing | ||
18 | Remove tape (12) | Anti-rattle tape | |
19 | Remove covers (13, 14) | ||
20 | Route subharnesses out of working area | ||
21 | Remove cover (16) | ||
22 | Release screw (17) by a few turns | Do not remove screw (17) completely. | |
23 | Unscrew nuts (18) | ||
24 | Remove housing (15) | ||
25.1 | Remove fuel injection system control unit | Model 470 with engine 200 | |
25.2 | Remove diesel injection system control unit | Model 470, 471 with engine 699 | |
26 | Route subharnesses out of working area | ||
27 | Remove bracket (1) | Model 470, 471 with code FX9 (KEYLESS-GO) | |
Unscrew bolt (2) to do this. | |||
28 | Remove insulation (3) | To do so, unscrew nuts (4). | |
29 | Remove bracket (5) | To do so, remove the bolts (6). | |
30 | Remove hood support (7) | ||
31 | Remove bracket (19) of hood support (7) | ||
32 | Route floor covering (20) out of the working area | ||
33 | Route insulation (21) out of the working area | ||
34 | Install in the reverse order |