S72.10-4659-09
Shown on left side of vehicle |
1 | Front door | 4 | Electrical door wiring harness | 6 | A-pillar | ||
2 | Cover | 4.1 | Electrical connector | 7 | Screw | ||
3 | Insulation mat | 5 | Grommet | 8 | Door holder |
Shown on left front door (1) |
1 | Front door |
9 | Nuts |
10 | Hinge |
S72.10-4660-06
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Topical note | Notes on carrying out repair work in the vehicle interior | ||
| Remove | ||
1 | Open side window of left or right front door (1) completely | ||
2 | Detach ground line of on-board electrical system battery | ||
3 | Remove left or right trim (2) in footwell | ||
4 | Fold up insulation mat (3) and pull out the electrical connectors (4.1, arrows) of the electric door wiring harness (4) from the A-pillar | The number of electrical connectors (arrows) varies depending on the vehicle equipment. | |
5 | Disconnect electrical connectors (4.1, arrows) | ||
6 | Remove grommet (5) from the A-pillar (6) | ||
7 | Pull out electrical door wiring harness (4) from the A-pillar (6) | ||
8 | Remove screw (7) and remove door holder (8) from A-pillar (6) | ||
9 | Install lifting device on front door (1) | ||
| 000 588 04 80 00 Lifting device | ||
10 | Unscrew nuts (9) and remove front door (1) from the hinges (10) | ||
11 | Remove front door (1) from the lifting device | If required. | |
Helper required. | |||
| Install | ||
12 | Install front door (1) on the lifting device | If required. | |
| 000 588 04 80 00 Lifting device | ||
Helper required. | |||
13 | Position front door (1) on the hinges (10) and tighten nuts (9) so that the front door (1) is fixed to the hinges (10) | Tighten nuts (9) with the specified tightening torque after adjusting the front door (1). | |
14 | Remove lifting device from the front door (1) | ||
15 | Position door holder (8) on A-pillar (6) and tighten screw (7) | Bolt, door holder at A-pillar | |
16 | Install electrical door wiring harness (4) in A-pillar (6) and route | ||
17 | Install grommet (5) in A-pillar (6) | ||
18 | Connect electrical connectors (4.1, arrows) of electric door wiring harness (4) | The number of electrical connectors (arrows) depends on the vehicle equipment. | |
19 | Position electrical connectors (4.1, arrows) in the A-pillar | ||
20 | Fold down insulation mat (3) | ||
21 | Install trim (2) in footwell | ||
22 | Connect ground line for on-board electrical system battery | ||
23 | Adjust front door (1) | ||
| Check | ||
24 | Perform function test of all component parts installed on or in the front door (1) |