Removing and installing lower oil reservoir cover

AR43.30-W-0009A

4.3.10

MODELS 930, 932, 933, 934, 950, 952, 953, 954 with CODE (BA9) Voith secondary retarder R 115

W43.30-0033-06

Illustrated on model 930

1 Lower oil reservoir cover

2 Seal

3 O-ring

4 Oil reservoir

5 Bolt

6 Bolt

 	Remove/Install
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
1	Engine control/permanent brake operating lever on position "0" and switch off ignition
 Danger!	Risk of injury due to touching the hot retarder surface or being scalded with hot retarder surface oil. Risk of injury to skin or eyes due to retarder oil spraying out under high pressure	Do not carry out any work unless retarder is switched off. Wear suitable protective clothing and safety glasses when working on the hot retarder surface	AS43.30-Z-0001-01A
2	Drain oil from retarder	 Drain oil when hot (hotter than 60 °C).
	Retarder - checking, correcting oil level		AP43.30-W-4310A
3	Detach lower oil reservoir cover (1) from oil reservoir (4)	 Installation : Replace O-rings (3) and gasket (2).
		Grease O-rings (3) with Vaseline	*BR00.45-Z-1015-06A
		Tighten lower oil reservoir cover (1) as per the specification.	AR43.30-W-0009-01A
			*BA43.30-N-1019-01A
4	Install in the reverse order

 Retarder

Number	Designation			Model 930, 932, 933, 934, 950, 952, 953, 954 with (code BA9) Voith secondary retarder R 115


BA43.30-N-1019-01A	Bolt, oil reservoir cover at bottom to oil reservoir	Initial torque	Nm	17
		Final torque	Nm	25

Repair materials

Number	Designation	Order number
BR00.45-Z-1015-06A	Vaseline	Karl Käppler GmbH & Co. KG Liebknechtstr. 48 70565 Stuttgart Germany Tel. +49 711 7868-481 Fax +49 711 7868-489 www.karl-kaeppler.de