S42.10-4613-08
Shown on model 470 |
1 | Stop lamp switch | 6 | Electrical connector | |
4 | Switch for brake pedal rear end position | Y | Dimension | |
5 | Bracket |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Topical note | Notes on carrying out repair work in the vehicle interior | ||
| Remove | ||
1 | Remove driver kneebag | ||
2 | Remove the brake light switch (1) with attached electric line and set aside | ||
3 | Turn switch for brake pedal rear end position (4) 45° in counterclockwise direction and remove from holder (5) | ||
4 | Release electrical connector (6), disconnect it and remove switch for brake pedal rear end position (4) | ||
| Install | ||
5 | Plug electrical connector (6) onto switch for brake pedal rear end position (4), until it is locked into place | ||
6 | Insert switch for brake pedal rear end position (4) into holder (5), adjust dimension (Y) and turn switch for brake pedal rear end position (4) 45° in clockwise direction | The brake pedal must be in the rear end position. | |
Distance from housing of switch for brake pedal rear end position to contact surface on brake pedal | |||
7 | Install switch for brake light (1) | ||
8 | Install driver kneebag |