S42.10-4613-08
Shown on model 470 |
1 | Stop lamp switch | 3 | Electrical connector | |
2 | Bracket | X | Dimension |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Topical note | Notes on carrying out repair work in the vehicle interior | ||
| Remove | ||
1 | Remove driver kneebag | ||
2 | Turn brake light switch (1) 45° in counterclockwise direction and pull out of holder (2) | ||
3 | Release electrical connector (3), disconnect it and remove brake light switch (1) | ||
| Install | ||
4 | Plug electrical connector (3) onto brake light switch (1) until it is locked in place | ||
5 | Guide brake light switch (1) into holder (2), adjust dimension (X) and turn brake light switch (1) 45° in clockwise direction | The brake pedal must be in the rear end position. | |
Distance from housing of brake light switch to contact surface on brake pedal | |||
6 | Install driver kneebag |