Removing, installing swing link

AR35.50-W-0090A

2.3.12

REAR AXLE 749.011

W35.50-1039-06

1 Bolt

2 Cover

3 Gasket

4 Locking bolt

5 Flange

6 Outer tapered roller bearing

7 Outside outer race

8 Rocker arm

9 Inside outer race

10 Radial seal

11 Inner tapered roller bearing

12 Thrust ring

13 Swing axle

14 Spring shackle

	Removing
1	Remove wheel hub with axle supporting tube		AR35.50-W-0085A
2	Support vehicle at frame
3	Remove cover (2)
4	Unscrew locking bolt (4) from flange (5)
5	Remove rocker arm (8) from swing axle (13)		AR35.50-W-0090-01A
			*000589696300
			*648589010700
			*648589013300
6	Remove outer tapered roller bearing (6) from rocker arm (8)
7	Remove radial seal (10)
8	Replace rocker arm bearing		AR35.50-W-0090-03A
			*000589453300
			*648589016300
		Hot-air gun
			*BR00.45-Z-1092-02A
	Installing
9	Install radial seal (10)	 Coat circumference of radial seal without rubberized external surface with sealant..	*BR00.45-Z-1092-02A
			*740589011500
10	Push rocker arm (8) onto swing axle (13)
11	Insert tapered roller bearing (6) into rocker arm (8)	 Heat tapered roller bearing to approx. 80 °C.
12	Tighten flange (5)	  Continuously turn rocker arm (8) so that tapered roller bearings fit in place and run free of clearance.	*BA35.50-N-1003-03A
			*000589696300
			*648589010700
13	Screw locking bolt (4) into flange (5)		*BA35.50-N-1004-03A
14	Install cover (2)		*BA35.50-N-1005-03A
15	Fit rocker arm (8) at spring shackle (14)		*BA35.50-N-1001-03A
16	Install wheel hub with axle supporting tube		AR35.50-W-0085A

 Trailing axle

Number	Designation		Trailing axle 749.011


BA35.50-N-1001-03A	Bolt, rocker arm to spring shackle	Nm	750
BA35.50-N-1003-03A	Flange to swing axle	Nm	1915
BA35.50-N-1004-03A	Flange locking bolt	Nm	150
BA35.50-N-1005-03A	Bolt, cover to rocker arm	Nm	10